0
To drain coolant from a Suzuki VZ800 Marauder, first ensure the engine is cool and the bike is on a level surface. Locate the drain plug on the engine's water pump or the radiator, typically at the lowest point. Place a container beneath the drain plug, remove the plug, and allow the coolant to fully drain out. Once finished, replace the drain plug securely before refilling with fresh coolant.
What else can I help you with?
How many quarts of oil does a 1998 Suzuki Marauder vz800 hold?
2.2quarts
How much radiator fluid is needed for a suzuki marauder vz800?
Approximately 1400ml
What could make timing jump on a suzuki marauder vz800?
Loose timing chain or belt.
Where do you check radiator fluid on a suzuki marauder?
On a Marauder VZ800 (1998), remove the black cap (triangle shap) on the right side at the front. There you can fill radiator fluid.
What is the Valve gap 800 marauder?
The gap for all valves is .003 to .005 inches (.08 to .13 mm). ( from 97-2002 Suzuki Marauder VZ800 service manual).
How much oil do you put in your 2003 suzuki marauder vz800?
2.5 qts with out a filter change and 3 qts with on my 2000
Oil capacity on a 2000 Suzuki Marauder VZ800?
About 2.2 quarts with a filter change and a little less than 2 quarts without changing the filter.
What are the float settings on 01 suzuki vz800 marauder for front and rear carburetors?
On the 2001 Suzuki VZ800 Marauder, the float settings for the front and rear carburetors are typically set at 13.5 mm. This measurement is taken from the gasket surface to the top of the float when the carburetor is held upside down. It's important to ensure that both carburetors are adjusted to the same specification for optimal performance. Always refer to the service manual for detailed procedures and specifications.
Where is the coolant drain on 98 navigator?
my drain is brok and i casn not get it out how can i drain the coolant?
Drain coolant Mazda 626?
To drain the coolant on a Mazda 626, locate the drain plug on the bottom of the radiator. Remove the plug and drain the coolant into a pan.
You found the drain plug but no coolant is coming out of the car?
Assuming there is coolant in the engine the most likely cause is a build up of sediment behind the coolant drain or in the coolant drain tap itself.
How do you drain coolant from 2002vt750dc shadow spirit?
To drain the coolant from a 2002 VT750DC Shadow Spirit, first ensure the engine is cool. Locate the coolant drain bolt at the bottom of the water pump or the radiator, depending on your configuration. Place a container underneath to catch the coolant, then remove the drain bolt and allow the coolant to flow out completely. After draining, reinsert the drain bolt and refill the system with fresh coolant.
