answersLogoWhite

0

Drill a hole in the botom.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the fuel filter located on a VE commodore?

in tank


When was Holden VE Commodore created?

Holden VE Commodore was created in 2006.


How do you remove washer bottle on ve commodore?

how do you remove the washer bottle on a ve commodore


would using 98 octane fuel cause check engine light to come on?

on a ve commodore


How do you replace fog lamp bulb on a ve commodore?

eazy way to change fog lamp on ve commodore 2007


Does a ve commodore have a canbus system?

Yes it does


What is the fuel tank capacity on a 2000 Toyota Corolla VE?

13.4 gals.


Where can I find more information on the Ve Commodore?

You can find more information about the Ve Commodore on the AU website Cars Guide. You can also get information from the auto maker's website, Holden.


How replace coolant in ve commodore?

To replace the coolant in a VE Commodore, first ensure the engine is cool, then locate the radiator drain plug and open it to drain the old coolant into a suitable container. Next, close the drain plug and fill the radiator with a mixture of coolant and water, typically in a 50:50 ratio, through the radiator cap. Start the engine and let it run for a few minutes with the heater on to help circulate the new coolant, then check for any leaks and top off the coolant reservoir as needed. Always dispose of the old coolant properly, as it is toxic.


Where is a fuel pump located in a 1996 Nissan maxima?

I´ve just changed the fuel pump from my 1996 maxima a few months ago, and it is located inside the fuel tank. You will have to remove the back seat, then remove the screws from the lid and there is a hose conected to the lid; have bucket or something to drain wath is left of gas in that hose otherwise it will spill all over,remove the lid, you will be able to see the gas pump. be sure not to do this with a full gas tank otherwise you will be wasting a lot of gas if you don´t have where to drain it.


How do you change the coolant on a VE commodore?

To change the coolant on a VE Commodore, start by ensuring the engine is cool and then remove the radiator cap. Place a drain pan under the radiator and open the drain valve to let the old coolant flow out. Once drained, close the valve and fill the radiator with a 50/50 mix of coolant and distilled water. Finally, run the engine for a few minutes to circulate the new coolant, check for leaks, and ensure the coolant level is correct before replacing the cap.


How do you reset the ve commodore check engine light?

I disconnected the battery and left doors open. I was thinking it would drain the capacitors. I left it for about 30 minutes. The check engine light was off and the warning on the dash disappeared.