It is very unique because the wire is thick, very thick and looks like a 1/2 inch wire. No other is like it. There is one from the negative terminal of the battery to the Car Body, and the other if it is not from the Block to the Car body, then it should be from the Transmission body to the car body. If the car body is not metal then ground it to the Chassis that forcely has to be metal. The problem is that the Chassis is always heavy to dig or open a hole to put the screw and nut. Remember always where you put the ground, or the place where is must be peel off, use sand paper!
The ground wire leads from the negative side of the battery and connects either to the engine block or to the frame of the automobile.
if it is a big power wire ( same size as the battery cable ) then it is the earth wire you should find that the battery has one wire going directly on to the engine or chassis there are different arangements the negative wire could be coming directly to the starter and if this is the case then the wire is just earthing the engine but in a lot of cases the starter is getting its ground from the engine and the engine gets its ground from the battery
The Chassis is the ground.
Connect it to the frame/chassis -- the major metal parts of the car, such as the walls of the engine compartment.
There are several ground wires - if you have a specific one in mind, please state which one it is. Some examples include the battery negative to ground (usually the chassis) and the engine block to ground.
There usually isn't one. The vehicle becomes the ground, and since the alternator is physically attached to the engine, the case of the alternator becomes the ground. Note that the battery is also connected to the vehicle chassis, usually at 2 or more points, and that the engine usually has a grounding strap to some solid point on the chassis.
In a Chevy S-10, the ground wire is typically connected to the vehicle's chassis or frame, often near the battery or engine block. You can usually find it on the driver's side of the engine compartment, where it connects to a metal surface to ensure a proper ground connection. Additionally, it may also be attached to the rear of the engine or under the dashboard, depending on the specific model year. Always refer to the vehicle's service manual for precise locations.
replace the ground wire cause its probably corroded
It is not going to hurt to ground it with a secondary ground if you suspect it is not grounded. It is not grounded thru the antenna. Just run a ground wire from the radio chassis to any ground location.It is not going to hurt to ground it with a secondary ground if you suspect it is not grounded. It is not grounded thru the antenna. Just run a ground wire from the radio chassis to any ground location.
A ground is a ground...You can put it to any metel part or screw as long as it makes contact with the chassis or frame.
Positive post of capacitor is connected to the heavy amp cable. The ground terminal (or case) of the capacitor is connected to the car's ground or a ground wire that leads to the car's chassis. That's it.
anywhere to the chassis of the truck