if its an older one it could possibly in the dome light the two contacts short out take it apart and put new contacts in
wind BLows
Because it's broken.
check your PCV Valve
most likely timing is off or a bad valve
YEP OF COURSE JUST MAKE SURE YOU MOVE WHEN IT BLOWS UP.gd
The motor which blows air through the vents.
The blades of a windmill are turned by the wind. When the wind blows, it causes the blades to rotate, generating mechanical energy that can be converted into electricity or used for other purposes.
I have vintage headlights converted to h4 halogen bulbs, my 30 amp fuse blows when i hit high beam, i was told to install a relay, hoe do i do this??
It's a short circuit in the wiring. You'll have to get a multimeter or test light and go over the whole wire for the headlights and check for continuity . If there's a current through it all is what youre checking. Hope it helps .
Short in the wiring.
Load is too large for the circuit, or there is a short in the wire you are hooking up.
There's duct work in or under the dash. Check to see if some of this duct work came apart.