answersLogoWhite

0

Have a rebuilt trans installed/

  • before going to the expense of a rebuilt trans there are two items that need to be checked first. the trans is controled by a computer that operates a set of externally mounted shift solenoids. either of these could cause the problem and they are much cheaper than a transmission.
  • The transmission computer depends on input from two sensors, an input shaft speed sensor and an output shaft speed sensor. If the wiring to either of these, or the sensors themselves are faulty, the transmission computer will also default to this mode.

BEFORE you replace the tranmission, go to your Chrysler dealer and let him read out the transmission error codes. It could be "only" the solenoid valve block, that has errors or maybe the TCM transmission control module is faulty. You will find boht parts (solenoid and TCM) in eBay for a few bucks

-> if it only works in 3rd gear, the tranny has not to be replaced. Maybe the selector wires are blocked or unhooked, first check this an try to oil them a bit. Otherwise, the Solenoid and/or the Filters are blocked with sticky, old tranny oil (ATF) then first unplug the battery for at least 12 hours (to reset the TCMs settings), remove the Transmission solenoid at the front side of the transmission, at the front side of the car (4 long screws) and 1 electric connectior. clean the solenoid in petrol or with using a lot of WD40, specially clean the 8 little oil seaves specially, rebuild all and in 90 % of all cases, the tranny will work again for the next 100000 miles or so, unless everything gets sticky again.

The best is to replace the replaceable part of the 9 Litres of Transmission Fluid (only ATF+3 or similar, never, NEVER use Dexron)), you will only be able to replace about 4-5 Litres, and do not forget to replace the Transmission fluid Filter below the Tranny

The Chrysler A604/41TE (and newer) transmissions are much much much better than their reputation and I know many of them working up to 500000 kms / over 300000 miles without any problems.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What fluid is used in the hydraulic lift cylinders of a 1987 Chrysler lebaron convertible?

Automatic transmission fluid.Automatic transmission fluid.


Will a convertible top from a 1989 Chrysler lebaron fit on a 1992 Chrysler lebaron convertible?

Yes


What kind of fluid do you put in a 1992 lebaron convertible top motor?

Automatic transmission fluid.


How do you add transmission fluid to a Chrysler lebaron automatic transmission?

You use a funnel and pour it down the dipstick hole.


Where do you add automatic transmission fluid at on a 1995 Chrysler Lebaron?

Through the trans dipstick tube.


Where is fuse box in a 1982 Chrysler lebaron?

I can't find the fuse box on my 1982 lebaron convertible chrysler


Where is the hydraulic reservoir for 1988 Chrysler lebaron convertible top?

Where is the hydraulic reservoir for 1988 Chysler Lebaron convertible top?


How do you change the transmission filter on a 1995 Chrysler LeBaron convertible?

To change the transmission filter on a 1995 Chrysler LeBaron convertible, start by draining the transmission fluid by removing the transmission pan. Once the pan is off, you'll see the filter; unbolt and remove it. Replace it with a new filter, ensuring any gaskets or seals are properly positioned. Reattach the pan, refill the transmission with fluid, and check for leaks.


Where is the fuel pump on a 1992 Chrysler Lebaron convertible?

The fuel pump on a 1992 Chrysler LeBaron is inside the fuel tank.


Is a 1991 lebaron convertible manual?

Most are automatic.


Did the 1989 Chrysler Lebaron Convertible come with ABS?

No.No.


Is there a hand crank for the convertible top on a 1993 Chrysler LeBaron?

No.