To fix burnt-out lights on a stereo, first, unplug the device to ensure safety. Open the stereo casing, usually by removing screws, to access the burnt-out bulbs or LED indicators. Replace the faulty bulbs with new ones of the same type or, if applicable, solder in new LEDs. Finally, reassemble the casing and plug the stereo back in to test the lights.
Have you checked fuses?
Open the trunk. Access to the tail lights is from there.
the dimmer control wire to the stereo lights is shorting out to fix need to take radio out and look real close at all the wires
What do you mean fix lights? which lights? Are the lights not working or does it have a broken lens. If the light doesn't work, have you checked the bulb? Is it burnt out? Is the socket in good working condition? Did you use you test light to see if it has power? Is the fuse good?
I remove my stereo from my GMC Truck and now my lights don't work
To fix a burnt armchair you should cut the part that was burnt. Meanwhile, try to find good looking arm chair from junk yard. Replace the part that was burnt.
Did you check to see if you blew a fuse when you had it installed? Was the battery disconnected when the stereo was installed? Either that or one of the wires to the gauges has either been miswired to broken the circuit and maybe possibly not grounded.
Did you recently change or install something in your car like a stereo or GPS?
Take it to a stereo shop.
I spliced mine in to the power wire on my raido. now if you had in installed go back and have them fix it.
with cellotape
Get a new one.