0
Use drip pans, because coolant contains chemicals which aren't good for the soil or groundwater. Place your drip pan under the radiator - at the bottom, there'll be a screw which you can take out to drain the radiator. Once the coolant is drained, take a garden hose, insert it into the radiator and turn the water on. Crank the motor, and let the water cycle. When it comes out clean, you'll have successfully flushed out your radiator. If you're unable to take the radiator drain plug out, you can disconnect the lower radiator hose instead.
What else can I help you with?
On a 1998 Chevrolet Malibu How do you flush the cooling system?
It is best to have it done professionally as they clean the cooling system as well as back flush it.
Cooling system 1998 expedition?
The cooling system in the 198 Expedition includes the radiator and its reservoir along with the thermostat. This system included an oil cooler as well, depending on the model purchased.
Why does your 1998 Sebring blow cold air while idling and hot air while moving?
This is often caused by air being trapped in the cooling system. Get a qualified mechanic to drain, flush and refill the radiator/cooling system.
How do you back flush the radiator cooling system on a Ford au falcan?
could you tell me how often should coolant be added to my 1998 el.ford futura thanks
What type of coolant is used in 1998 Ford Expedition?
According to the 1998 Ford Expedition Owner Guide : The engine cooling system came with a 50 / 50 mix of distilled water and GREEN color antifreeze ( meeting Ford specification ESE-M97B44-A )
How do you depressurize fuel system to install filter 1998 ford expedition?
How do you depressurize fuel system to install filter 1998 ford expedition?
How do you Flush radiator 1998 Ford Expedition?
I would suggest purchasing a "flush kit" from any local auto parts store. Follow the directions on the flush kit and be sure to recycle the old coolant. It is easier than it looks.
How do you flush the coolant system on Renault laguna 1.8 1998?
To flush the coolant system on a 1998 Renault Laguna 1.8, first ensure the engine is cool and then remove the radiator cap. Drain the old coolant by opening the drain plug at the bottom of the radiator, allowing the fluid to flow into a suitable container. Next, close the drain plug, fill the system with a mixture of water and a cooling system flush product, run the engine until it reaches operating temperature, and then drain it again. Finally, refill the system with fresh coolant and bleed any air from the system by using the bleed valve, if present.
What ia a COP in a 1998 Ford Expedition?
The 5.4 liter V8 engine , available in the 1998 Ford Expedition has a Coil On Plug ( C.O.P. ) ignition system
How do you replace a lower radiator hose in a 1998 Expedition?
To replace the lower radiator hose on a 1998 Ford Expedition, first ensure the engine is cool and then relieve the pressure in the cooling system by removing the radiator cap. Next, use a wrench to loosen the clamps at both ends of the hose, then carefully remove the old hose. Install the new hose by sliding it onto the radiator and engine fittings, securing it with the clamps, and finally, refill the cooling system with the appropriate coolant and check for leaks.
Where is a diagram of a 1998 dodge Dakota cooling system?
It is important to have a diagram of the area of the car that is being worked upon. The cooling system diagram for a 1998 Dodge Dakota is found in its maintenance manual.
How do you flush the radiator for a 1998 suburban?
The easy way is to buy a flush kit from prestone ($7) and follow the directions. You will basically be splicing in a tee fitting that accepts your garden hose, and adding a can of flush to the cooling system. After 10 minutes of run time you will turn or the hose and 'backflush' the old coolant out the top of the radiator. Messy, but it works. I hope this helps you. Mark
