To remove the dome light cover, gently pry it off using a flathead screwdriver or your fingers. Be careful not to break the clips holding it in place.
To remove the dome light cover, gently pry it off using a flathead screwdriver or your fingers. Be careful not to break the cover or damage the surrounding area.
Take the cover off the dome light with a flat head screwdriver. Insert the screwdriver carefully into the small indet in the back of the dome light. pry carefully and the cover will pop off. Pull the bulb out and snapo the new one in. For side bulbs you will need to use a Phillips screwdriver and remover the dome light from the ceiling after the cover is removed.
AnswerThey are usually held in place by 2 or 4 clips built into the cover. Squeezing or carefully prying the cover sideways and it will come off.I dont need to just take off the cover, because it was busted so bad i have to remove the dome the light is place in. i need to replace the dome, cover, and light.
If you need to replace your dome light switch you will need to remove the cover first. You can use your fingernails or even a small knife to get the cover off.
You can replace the dome light bulb in a 2002 Chevy Cavalier by first prying the dome light cover off of the light. Then, remove the bulb and replace it by twisting the bulb from the socket.
Just gingerly pry it off.
The dome light cover is made of hard plastic and snaps into place. Squeeze the cover just enough to snap it out of place.
To replace the dome light cover in your car, first, locate the cover and gently pry it off using a flathead screwdriver. Then, remove the old cover and replace it with a new one by snapping it back into place. Make sure it is securely attached before testing the light.
I just slide a credit card between the cover and the ceiling and it popped right off.
According to the owner's manual, you pry it off by prying at the front of the cover. Do it carefully
If you look closely at the dome light cover you will notice two small notches in one side of the cover. Simply take a knife and put into the notches with a gentle prying motion. The cover should come right off and you should have access to the light.