answersLogoWhite

0

pull it off haah!

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

5hp B and S engine shears key in flywheel on shutdown Why?

Something has bound the shaft or crank on the engine to cause the key to pop. Could be if it backfired - that will cause the shear pin to break - or if you caught something underneath it with the blades that would cause it.


How many poles in a 5hp 1740 rpm motor?

Motherf****r I Dont Know B****


A blueprint on a 5hp Briggs and stratton?

Checking at your local public library for a manual on small engines repair would probably be the easiest way to find B&S and other small engine "blow-up" diagrams and repair guides. Suggestion: If you get the Model and Code numbers from your engine, you might find a manual specific to your engine.


Will b16 tranny fit a h22a engine?

No. Bisimoto (and a few others) sell a H2B kit which works as an adapter plate / flywheel between the H-series engine and B-series tranny. They are crazy expensive though and no where worth it if you aren't into racing.


Where are points on 5 hp B and S 130202?

Under a cap that is under the flywheel.


What would cause a b and s engine not to run right?

First off you are running a bs engine. So there is your problem right there.


Can you put a b-series Honda engine on a d-series hona gearbox?

yes you can, you have to use the b-series flywheel and the b-series pressure plate, but you have to use the d-series clutch disk. because the input shaft on the d-series is different than the b-series, so the b-series clutch disks splines are different, that's why you have to use that disk.


Where is the starter on a 1994 Ford Escort?

There were 2 motors in the escort that year. B Clear. near the flywheel, would be a good guess... look to where the transmission bell housing mates with the engine block on both the front and back of the engine you will find a motor with a positive battery cable connected to it. It's on the back of the engine under the intake manifold, so you have to reach up from underneath. Take off wires after disconnecting battery, then 3 bolts out of the bellhousing to drop it out.


Is there a way to rewire a 5hp 3phase motor to run off of 240v without buying additional equipment?

No, you only have phase a and b. The motor will run as smoothly as a 3 phase motor that has lost a leg of power. That is if the motor is designed for 208v in the first place. Not a good idea.


Where is crank sensor on vectra b?

On a Vauxhall Vectra B, the crankshaft position sensor is typically located near the engine's crankshaft, often on the lower part of the engine block. It's usually positioned near the flywheel or behind the engine, close to the transmission. To access it, you may need to lift the vehicle and remove any obstructions, such as the protective undertray. Always refer to the specific service manual for your vehicle for precise location and removal instructions.


Are there points on a 16.5 Briggs and stratton engine?

Nope. All modern B&S engines use Magnetron (R) solid state ignition. Check plug, wiring, armature (coil) air gap, flywheel magnet condition, flywheel key, etc. for no spark conditions. When all else fails, try a new armature ($$$). Timing is permanently set by factory.


How do you turn off or reset the check fuel cap light on a 1997 for a Mazda B 2300?

how do you turn off or reset the check fuel cap light on a 1997 Mazda b 2300 2.3 4 cylinder engine.