RCA connectors are used for line level signals. The RCA subwoofer output on you Home Theater receiver cannot drive a bare speaker. You will need an amplifier to boost the RCA line level signal up to speaker level.
You can buy a speaker harness. An adapter that connect the positive and negative from the speaker into the stock harness.
The current stock marketsentiment is variable. It can be positive and/or negative, depending on current trends. It is a good idea to check up on the stock market multiple times a day to see.
cool
Dark blue is positive and light blue negative on right side and brown positive and yellow negative on the left.
The easiest way is to test both sides with a multimeter. The positive side is the side transmitting the wattage to the speaker. The negative side is simply the ground. Also, automotive speakers typically have two different sized terminals and will be clearly marked with a + and a -. Hopefully you did not already cut the stock wiring harness out of the door. The easiest way to connect aftermarket speakers is to buy a matching speaker harness (found at Best Buy and other retailers). Connect it to the speaker and it will simply click right into the stock door harness. No guessing needed. This doesn't apply to all applications, but most times, the positive wire will be the one with the tracer markings (a white or black line down the length of the wire, or sometimes the lettering of the name of the wire manufacturer).
1991 Toyota Previa Car Audio Wire Color CodesCar Radio Battery Constant 12v+ Wire: Blue/YellowCar Radio Accessory Switched 12v+ Wire: GrayCar Radio Ground Wire: BrownCar Radio Illumination Wire: GreenCar Stereo Dimmer Wire: N/ACar Stereo Antenna Trigger Wire: Black/RedCar Stereo Amp Trigger Wire: N/ACar Stereo Amplifier Location: N/ACar Audio Front Speakers Size: 5 1/4″ SpeakersCar Audio Front Speakers Location: Side PanelsLeft Front Speaker Positive Wire (+): PinkLeft Front Speaker Negative Wire (-): PurpleRight Front Speaker Positive Wire (+): GreenRight Front Speaker Negative Wire (-): BlueCar Audio Rear Speakers Size: 5 1/4″ SpeakersCar Audio Rear Speakers Location: Rear SidesLeft Rear Speaker Positive Wire (+): BlackLeft Rear Speaker Negative Wire (-): YellowRight Rear Speaker Positive Wire (+): RedRight Rear Speaker Negative Wire (-): WhiteCheck size of speakers as I believe they are wrong here. Says rear is 5 1/4 but I have a stock rear speaker that is 6x9
stock speaker size for the mazda b3000 04 is 6x8
No...not really
A Stock market speculation means - Predicting the price of a market entity (A Stock for example) in future. If the speculation is positive, we buy. If our speculation is negative, we don't bye or sellbuy low sell high
Mono amp: hook up 2 wires to the positive speaker output, and 2 wires to the negative speaker output. Hook the positives up to the positive leads on the subs, and the negatives to the negatives. Stereo amp: one positive wire to each positive output on the amp, same with negative. Make sure you get corresponding positive and negative to each sub. Stereo amp running bridged (mono): It's normally the outter positive and negative leads, but refer to the manual. Wire same way as a mono amp, just use the bridge outputs. Mono or Bridged would be running 2 ohms if you are running single coil subs. Stereo would be 4 ohms. If you have a dual coil sub (such as Kicker Comp VR), you would want to run stereo because those subs run 2 ohm's stock do to the dual voice coils. Or 1 amp per sub unless you have a 1 ohm stable amp, which most likely you don't.
A Stock market speculation means - Predicting the price of a market entity (A Stock for example) in future. If the speculation is positive, we buy. If our speculation is negative, we don't bye or sellbuy low sell high
What are the stock speaker size in a 2003 mustang v6?