answersLogoWhite

0

drive belt for what on this vehicle? do u mean serpentine belt,or fan belt,or timing belt?

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you install a drive belt for a 1995 poniac gran am?

how to install a drive belt for a 1995 poniac gran am


How do you install a drive belt on a 2000 jeep wrangler 2.5 liter?

how to install a drive belt on a 2000 jeep wrangler 2.5 liter


How to install a polaris ATV drive belt?

remove clutch cover. remove old belt. install new belt.


How do you put a drive belt on a Kubota t1460?

I need to know the number for the drive belt. The one that drives the tractor.


How do you install drive belt of a Toyota Corolla?

Find out


How do you install ac drive belt on 2002 montero sport 3.5L Bolt does not loosen pulley only tightens it?

To install the AC drive belt on a 2002 Montero Sport 3.5L, you must first locate the tensioner pulley. Instead of trying to loosen the bolt, use a socket or wrench to rotate the tensioner in the direction specified in the vehicle manual, which typically releases tension on the belt. Once the tension is released, you can slip the old belt off and install the new belt, ensuring it follows the correct routing. Finally, release the tensioner to tighten the belt, ensuring it's properly seated on all pulleys.


How do you tighten a loose drive belt on 2002 altima Nissan?

I replaced an alternator on a 2002 Nissan Altima but the drive belt is now too loose even with it having an automatic belt tensioner


How do you replace the serpentine belt on a 2000 Chevy Corvette?

Remove the air intake duct, if necessary. Refer to Air Cleaner Assembly Replacement in Engine Controls - 5.7 L. Install a breaker bar with hex-head socket to the drive belt tensioner bolt. Rotate the drive belt tensioner clockwise in order to relieve tension on the accessory drive belt. Remove the accessory drive belt from the pulleys and tensioner. Slowly release tension on the drive belt tensioner. Remove the breaker bar and socket from the drive belt tensioner bolt. Clean and inspect the drive belt surfaces of all the pulleys. Route the accessory drive belt around all the pulleys except the water pump pulley and tensioner. Install a breaker bar with hex-head socket to the drive belt tensioner bolt. Rotate the drive belt tensioner clockwise in order to relieve tension on the drive belt tensioner. Install the accessory drive belt under the water pump pulley. Install the accessory drive belt onto the drive belt tensioner. Slowly release the tension. Remove the breaker bar and socket from the drive belt tensioner bolt. Install the air intake duct, if necessary. Refer to Air Cleaner Assembly Replacement in Engine Controls - 5.7 L. Inspect the accessory drive belt for correct alignment.


How do you install a Bobcat 863 drive belt?

how do i install the timing pins on a875 bob cat skid loader to replace the timing belt


The drive belt on your 2002 Ford Ranger Edge busted and then once you fixed it it slipped off again you can't find the place to install it where is the proper place to install it?

There should be a sticker in your engine compartment , ahead of the radiator or perhaps on the fan shroud , that shows a diagram on how to route your serpentine drive belt around all the pulleys.


Does a 2002 Suzuki xl7 have a timing belt or gear drive?

no


Why is your drive belt loose on your 2002 Mazda b3000?

bad belt, bad tesionure pulley, wrong belt, stretched belt