0
Well it really depends on what year your contour is I have a 1999 contour SE and mine is in the wing that has a few screws that have to come out and you can pull the light assembly out and change the bulb. But if yours is older and its behind the rear window take the plastic cover off usually it has one or two screws holding it in place unscrew it pull it back or up being easy with it and you can now change the bulb and now when your done put the cover back in place put the screws in place and snug the screws tight Warning do not over tighten because the plastic will break or crack very easily and now your done . This should take you less than 5 minutes to do and its that easy.
What else can I help you with?
How do you change the center third brake light on a 2003 E320?
Begin by removing the wiring harness from your third brake light. Remove the third brake light retaining screws. Reverse the process to install your new third brake light.
Where is the fuse for the third brake light on a 2001 F-150?
the third brake light is direct from brake light switch no fuse
Why does the third brake light work but not the other two brake lights I have a 1996 Ford Contour?
I am not sure on a ford but i had about the same problem on a GM car i had and it was the turn signal switch i replaced it and all the brake lights worked fine you might try that
Third brake light on a 96 Chevy beretta?
how to change third or center brake light on Chevy beretta 95
How do you replace third brake light in 2009 Hyundai sonata?
How to change third brake light in 2009 Hyundai sonata
Who was the third rear brake light named for?
The third brake light is named for then Secretary of Transportation Elizabeth Dole and are called "dole lights".
What year did Chevelle introduce the third brake light?
Chevelles never had a third brake light since the Chevelle name was dropped after 1977. However, third brake lights were first installed (and required) in 1986.
How do you remove a third brake light?
with a hammer
How do i replace the third brake light on a Lincoln ls?
To replace the third brake light on a Lincoln LS, first, open the trunk and locate the access panel or cover for the brake light assembly. Remove any screws or clips securing the panel and gently pry it off. Disconnect the wiring harness from the old light, then remove the old light bulb or assembly. Install the new light by connecting the wiring and reversing the removal steps to secure everything back in place.
What is a third brake light used for?
A third brake light is used to provide a deceleration warning to vehicles that can't see the left and right lights. You can learn more about these brake lights at the Wikipedia.
Why do your brake lights work but the third brake light does not and not the ABS light is on?
New bulb needed or broken wire
Did a 1989 Chevy truck have a third brake light or just a cargo light?
The 1989 Chevy truck did not come with a third brake light as a standard feature. Instead, it typically had a cargo light above the truck bed. However, some later models and trims may have included a third brake light, but it was not common for that year.
