they will break. just use sense when doing so tighten down until snug then a 1/3 extra turn it should tell you on the box
spark plug is lose or oring is missin off plug try changing the plug and make sure its tight but dont over tighten it
In your tool kit you should have a rench that will fit on the plug. You pull off the spark plug wire and take out the spark plug. Make sure the gap is set right for the new plug and put in in. Do not over tighten.
All spark plugs are rotated clockwise to tighten and counterclockwise to loosen.
Snug. People always want to over tighten them. They're not going to fall out.
The threads in the head may be dirty. Try cleaning them out with a round wire brush. If that does not work, try a different plug. If another spark plug will not tighten, then the threads in the head are damaged and you need them professionally repaired.
same as any other car u remove the spark lead from the top of the engine beside the rocker cover then use a spark plug socket (which is longer than a normal one) to remove each spark plug be careful to put the leads back onto the same spark plug you removed and not to over tighten the spark plugs.
I just tighten them with a regular spark plug socket rachet. You should be able to feel when to stop tightening.
To change the spark plug on a Honda Rincon, first, ensure the engine is cool and disconnect the negative battery terminal. Remove the spark plug cap and use a spark plug socket to carefully unscrew the old spark plug. Before installing the new spark plug, check the gap and adjust it if necessary. Finally, screw in the new spark plug by hand, tighten it with the socket, reattach the spark plug cap, and reconnect the battery.
To change the spark plugs in a Chevy Celebrity: 1. Give the spark plug boot a twist to free it up from the spark plug, then pull on the boot to remove the spark plug wire from the spark plug. 2. Use a 5/8" spark plug socket with an extension and ratchet or breaker bar to loosen then remove the spark plug. 3. Set the gap on the new plug to .045" then screw it back into the spark plug hole in the head. Tighten the spark plug and replace the spark plug wire. I change the spark plugs one at a time to keep from getting the spark plug wires on the wrong spark plug.
To replace the spark plug on a 2004 Polaris Sportsman 700, first, ensure the engine is cool and disconnect the spark plug wire. Use a socket wrench to remove the old spark plug by turning it counterclockwise. Before installing the new spark plug, check the gap and adjust if necessary. Finally, insert the new spark plug, tighten it securely, and reconnect the spark plug wire.
To perform a weed eater spark plug replacement, first ensure the engine is cool. Locate the spark plug on the engine and use a spark plug wrench to remove it. Check the gap on the new spark plug and adjust if necessary. Install the new spark plug by hand, then tighten it with the wrench. Finally, reconnect the spark plug wire and test the weed eater to ensure it is running smoothly.
You pull the ruber boot off the top of the spark plug , take the plug out, put boot back on the plug, touch steel part of the plug to steel on motor,pull motor over while watching the gap on the plug if you see spark it should be ok if no spark do the same with a spark plug you know is good to make sure it is the plug. Hope this helps