On the Ford Explorer you pull the hood release inside the vehicle which causes the hood to pop up slightly. Then you reach in through the grill at the front of the Explorer, near the top of the grill just under the hood and slightly left of the center of the grill. Move the secondary catch lever to the right and lift the hood. If the hood won't open, a second person inside pulling on the hood release while the other person operates the secondary catch lever may be necessary if the latch needs to be lubricated.
The easy way to open the hood manually on a 1998 Chevy Cavalier, when the cable is not working is to put the car on a hoist and use a long pole to trip the hood latch. Then lower the vehicle and open the hood the rest of the way. Replace or repair the cable for the hood latch before closing the hood.
To open the hood of a Mazda RX-8 manually, first, locate the hood release lever inside the vehicle, usually found on the driver's side near the footwell. Pull the lever to release the initial latch. Then, go to the front of the car, slide your hand under the hood, and locate the secondary latch in the center. Push or lift this latch to fully open the hood.
get a can opener
Just get a cable lock and wrap it through your hood and onto something solid in your car. leave enough slack to get the hood open a little and be able to undo the lock.
Rock got stuck under the hood in the latch release.
If the cable is broke you can crawl under and manually release the hood. It isn't too bad, the area is open and visible from under the car.
If the hood release on a VW Jetta is broken, whether its the cable or the plastic piece, you will need to remove the center shield under the vehicle. It is connected by four screws. Reach up under the vehicle and manually push the hood cable down with your hands to pop it open.
Yes. Open the hood and there is an access to crank them open.
Go under the dash board on the drivers side of the vehicle, behind it you will see the cable which is connected to the hood release handle. Grab a set of pliers, and grip the cable, (by the exposed part of the cable if possible) then pull it towards you, or put tension on the cable until the hood latch releases. The hood should open right up.
To open the hood on a Itasca Navion, locate the hood release lever inside the vehicle, typically found on the driver's side near the footwell. Pull the lever to disengage the hood latch. Then, go to the front of the vehicle and lift the hood; it may have a prop rod that needs to be secured to hold the hood open. Always ensure the vehicle is parked on a flat surface and the ignition is off before opening the hood.
do you not have a key to open the door? if you do, use it to open the trunk and climb through to open the door manually
pray and pray or beg and beg or cry and cry