0
I am assuming you have the driveshaft out. The next thing to do is remove the exhaust pipe section that goes between the manifold and the flange just after the catalytic converter. Remove the hydraulic clutch line on the left side of the bell housing by pushing the white plastic bushing in all the way then remove the line. remove the nut holding the trans mount to the cross member remove ALL the bell housing to motor bolts slide the transmission back to get the input shaft out of the clutch VERY CAREFULLY remove the trans from the truck. this might be easier if you place a hydraulic jack under it first.
What else can I help you with?
What is the fluid capacity of a 91 s10 5 speed manual transmission?
The transmission fluid capacity for a 1991 S10 5 speed manual transmission is approximately 3 quarts. This can be purchased at any auto parts store.
Will a 5 speed manual transmission from s10 bolt to a 327 engine?
If the tranny came off the v6 s10
What fluid type is used in a 1998 Chevy s10 speed manual transmission?
Mercon works.
92 S10 2 wheel drive 2.8L 6-cylinder 5 speed manual transmission?
What about it?
What 4-speed manual transmissions were offered with a 1985 S10 with a 2.8l v6?
The 1985 Chevrolet S10 light truck came factory equipped with the 2.8L 6-cylinder (engine code 'B') in both automatic and manual transmission options. The manual transmission type was the 5-speed F5M22-2.
What manual fluid does 1998 Chevy s10 2.2 liter take?
The manual transmission uses Mercon. i have 1998 s10 with 5 speed trans i was told to use syncromesh trans fluid
What is the fluid type and capacity for a 1991 Chevy or GMC S10 or S15 5 speed manual transmission?
The 1991 Chevy or GMC S10/S15 with a 5-speed manual transmission typically uses GM's manual transmission fluid, often referred to as GM Synchromesh or an equivalent fluid. The capacity for the transmission is approximately 2.5 to 3 quarts, depending on the specific model and configuration. Always check the owner's manual or service manual for exact specifications.
How hard is to remove a 1992 Chevy s10 5 speed transmission?
If you have the right tools and a transmission jack, it's quite easy.
How hard is it to remove a 1992 Chevy s10 5 speed transmission?
If you have the right tools and a transmission jack, it's quite easy.
How do you check transmission fluid on a Chevy S10 5 speed manual tranny?
There is a plug on the side of the tranny. take it out. If fluid runs out, put the plug back in the hole and get on with life. If no fluid runs out, check your manual for what transmission fluid to use. Fill it till it runs out at the plug a bit. Be sure to use the transmission fluid recommended for Chevy S10 5 speed manual transmissions.
Where is the backup-neutral switch on a 1998 Chevy S10 4-cylinder?
The switch is on the left sie of the transmission just in front of the speed sensor for a manual transmission.
What is the towing capacity for a 2001 Chevy S10 with a 2.2 engine a 5 speed manual transmission?
my 2000 s10 with a 2.2 5 speed is rated at 2000 pounds. so i think the 2001 is the same also.
