open the hood then undo the positive red battery cable then undo the negative cable and you will need a 10mm socket wrench to loosen the safety clamp hold plate that keeps the battery from turning over
do this and your done
You will need to remove the ignition switch retaining ring in your 2002 Chevy Astro Van. Slide the ignition switch out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.
under the battery, remove the battery and battery tray
Where is bank 1 on a 2002 chevy astro van
The 2002 Chevrolet Astro Van passenger door panel is held in place with two retaining screws and eight retaining clips. Remove the retaining screws and pry outward on the retaining clips.
To change the alternator on a 2002 Chevy Astro van, first disconnect the negative battery cable to ensure safety. Then, remove the serpentine belt by releasing tension from the tensioner pulley. Next, unbolt the alternator from its mounting bracket and disconnect the electrical connections. Finally, install the new alternator by reversing the steps, ensuring all connections are secure and the belt is properly reinstalled.
There is no ABS relay on a Chevy 2002 Astro Van. If the ABS light is on it is indicating a problem with the vehicle that should be checked out.
Take wheel off, remove brakes/caliper, remove dust cap, remove cotter pin, remove nut/washers and its off
Yes it would be easer to get at it with the dog house removed.
Yes. The lug pattern is the same on all Astro vans up to 2001. 2002 they went to a six lug pattern.
On a 2002 Chevy Astro van, the knock sensor is located on the engine block, typically on the passenger side. It is situated near the oil filter, mounted directly to the engine. You may need to remove certain components, such as the intake manifold or air cleaner assembly, for easier access to the sensor.
How do I remove the rear shocks on a 2002 chevy camaro convertible?
How do you remove and replace wiper switch on 2002 Chevy Cavalier