The trick is the bolt at the bottom of the panel that must be removed. You can see the head by looking in the crease at the bottom of the panel. Just loosen the bolt head (10 mm open end wrench)...do not remove...panel will slip out. Let me know if you need any more info. George
yes
Front, in the engine bay.
To replace the battery on a 1979 Corvette, disconnect the battery cables using the proper tool. Remove the bar that holds the battery in place and pull out the battery. Place the new battery in and reconnect the cables.
Remove the lower panel from left fender .
will a 1985 corvette hood fit a 1993 corvette
Start by removing the ground cable first(negative). Then remove the positive cable. At the base of the battery is a hold down clamp, held in by one bolt. Remove this and the battery will lift right out.
Open hatch behind drivers seat......remove battery cables.....remove battery hold down clamp at lower back flange of battery...pull out battery....replace in reverse order.
You need to remove the small vented side panel. or at least remove the 3 screws from the wheel well and the one on the top of the panel. Then pull the panel out enought to remove the battery
Remove the positive cable from your 1975 Chevrolet Corvette battery. Remove the two cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
Remove the positive cable from your 1995 Chevy Corvette battery. Remove the cables from the front of your old starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
just like any other battery nothing special disconnect the terminals, remove the battery and put new one in
The 1993 Chevrolet Corvette inside door panels are held in place with eight retaining clips and two retaining bolts. The retaining bolts will be near the door handle. Remove the retaining bolts and pry outward on the retaining clips.