Start by removing the ground cable first(negative). Then remove the positive cable. At the base of the battery is a hold down clamp, held in by one bolt. Remove this and the battery will lift right out.
== ==
To replace the battery on a 1979 Corvette, disconnect the battery cables using the proper tool. Remove the bar that holds the battery in place and pull out the battery. Place the new battery in and reconnect the cables.
Remove the lower panel from left fender .
Open hatch behind drivers seat......remove battery cables.....remove battery hold down clamp at lower back flange of battery...pull out battery....replace in reverse order.
Remove the positive cable from your 1975 Chevrolet Corvette battery. Remove the two cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
Remove the positive cable from your 1995 Chevy Corvette battery. Remove the cables from the front of your old starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
You need to remove the small vented side panel. or at least remove the 3 screws from the wheel well and the one on the top of the panel. Then pull the panel out enought to remove the battery
just like any other battery nothing special disconnect the terminals, remove the battery and put new one in
To remove the heater core from a 1999 Chevrolet Corvette, start by disconnecting the negative battery cable and draining the coolant. Then, remove the dashboard and center console to access the HVAC housing. Disconnect the heater core hoses from the engine compartment, unbolt the heater core from the HVAC assembly, and carefully extract it. Reassemble by reversing the process, ensuring all connections are secure and the coolant system is properly refilled.
i usually use a sawsawll. or a table saw.
first remove the cables from battery, neg, than positive, remove hold down bolt on bottom of battery. remove battery.
yes