To remove the CV joint on the passenger side of a 1999 Mazda, first, lift the vehicle and secure it on jack stands. Remove the wheel and brake components, then disconnect the lower control arm from the steering knuckle. Next, remove the axle nut using a socket, and then gently pry the CV joint out of the transmission or differential. Finally, pull the axle out from the wheel hub assembly to complete the removal.
Remove passenger side Rack and pinion arm and slide out Alternator .
remove passenger side signal front light first then passenger headlight and horn should be right behind below the side passenger signal light!
The horn is located on the front passenger side of the car. if you remove the front passenger headlight you will be able to see it from there
passenger side kick panel. remove it, and you will see the tcm
Under the dash - center console. Remove the side cover on the center console on the passenger side and you will see it on the floor board.
passenger front right side panel remove panel and the switch should be there
Directly under the intake manifold on the passenger side of the engine. If you have thin arms, it is possible to reach it from above the engine. Otherwise, if you remove the passenger side tire, you will find it there.
Directly under the intake manifold on the passenger side of the engine. If you have thin arms, it is possible to reach it from above the engine. Otherwise, if you remove the passenger side tire, you will find it there.
The firing order for the spark plugs in a 2000 Mazda B3000 start on the passenger side. The order is as follows - passenger side front, passenger side center, passenger side rear, driver side front, driver side center, driver side rear.
To replace the passenger side drive axle on a 2003 Mazda 6, start by safely lifting the vehicle and removing the front wheel on the passenger side. Disconnect the lower ball joint and any necessary components to gain access to the axle. Remove the axle nut and pull the axle out of the hub, then slide the inner end out of the transmission or differential. Install the new axle by reversing the steps, ensuring all components are securely reattached and the axle nut is properly torqued.
Do not attempt
passenger side under hood, where the hood meets the windshield you have to remove a few scews on the plastic trim