0
you need a socket set with an extension
1. open the hood
2. located the 4 bolts holding on the bumper just in front of the radiator
3. remove one bolt from each side
4. have a friend hold one side of the bumper while you remove the last 2 bolts
having a friend there is important cuz dak bumpers are oddly weighted and hard to carry by your self
What else can I help you with?
Can a rear bumper from a Chrysler 300 fit on a 2005 Dodge Magnum?
No
How do you remove the front bumper on a 2001 dodge Dakota?
There are a flat head nuts on the back side of the bummer, you will need to remove these nuts then pull the bolts out. the bumper (if it has not already done so) the bumper will fall off. If you also wish to remove the braces you can do so just as easily.
How much Dodge Dakota 4.7 magnum horsepower?
Anthony
How much does a Dodge Dakota 4.1 liter magnum weigh?
There is no such thing as a 4.1 liter magnum
How do you remove rear bumper on Dodge Magnum?
To remove the rear bumper on a Dodge Magnum, first, ensure the vehicle is turned off and parked on a flat surface. Begin by removing any screws or bolts located in the wheel wells and underneath the bumper, typically found near the rear fender and the rear frame. Next, detach any clips or fasteners holding the bumper in place, and carefully pull the bumper away from the car, starting from one side. Finally, disconnect any electrical connections for lights if applicable before fully removing the bumper.
How do you remove the front bumper on a 2004 dodge Dakota?
Support the bumper with a jack or jackstandWith an assistant supporting the bumper remove the bolts/nuts retaining the bumper to the frameRemove the inner bumper bracket mounting bolts and the push-in fastners securing the air deflector to the bottom of the bumper fasciaDisconnect any wiring harnesses that would interfere with bumper removal and detach the bumper
Is the 2005 Dodge Dakota 3.7L Magnum Engine Fuel Injected?
Yes.
Will a V8 magnum fit in a 2002 dodge Dakota that has a 3.9L V6?
YES
How do you remove a fender and bumper from a 1998 Dodge Dakota pickup?
You have to have a little mechanic ability to unbolt them and reinstall them. ^^^^that is a given, here is a step by step instruction on how to remove the bumper on a Dodge Dakota 98-99 (i'm sure it's the same for a few other years mainly generation 2 Dakota's), and a list of tools needed. Tools needed: 18 mm Socket and a ratchet WD-40/PB Blaster #2 Phillips bit screwdriver / flat head (in order to remove bumper cover) how to remove the bumper: 1.) pop your hood and open it all the way 2.) look down in front of your coolant overflow tank and just to the left of the radiator 3.) remove the four 18mm bolts from bumper 4.) pull bumper out (if you need to remove the brakets that the bumper is bolted to then you need a T50 star bit and a 3/4 inch socket with a 6" extention)
How many liters is your 2000 dodge Dakota v8 magnum?
5.2, 5.9, 4.7,??????
How many gallons of gas does a 1995 dodge Dakota v6 magnum hold?
15?
How do you remove transmission from 1988 dodge Dakota 4x4 3.9liter motor?
How do I get to the flywheel bolts on a 98 dodge dakota to remove a transmission
