To remove the front bumper on a Mk4 Fiesta, start by ensuring the vehicle is turned off and parked on a flat surface. Remove any screws or bolts located in the wheel arches and underneath the bumper, often requiring a Torx or socket wrench. Next, carefully pull the bumper away from the clips holding it in place, taking care not to damage any wiring or connectors. Finally, disconnect any electrical connections for fog lights or sensors, if applicable, to fully detach the bumper.
If you have the mk5 then the mk5 zetec-s bumper will fit straight on. If you have the mk4 the zetec s bumper will need cutting and trimming to make it fit but they do fit with work. Best way to check if you have a mk4 or 5 is by the lights. If you have the same shape lights as the ZS then you have a mk5 if not then you have a mk4. P.S. that was for the front bumper. Im not 100% sure on the rear. The ZS rear will fit straight on the mk5 and I have been told they fit on the mk4 with no work at all but I cant be 100% sure as iv never done it.
No, the floor pans are completely different. The MK3.5 will fit the MK4.
Yes,the mk4 and 5 chassis' are identical and generally any fiesta front wheel drivetrain can be transplanted into any other fiesta engine bay up to mk6.
Not all mk4 fiesta 1.3 have pas.
mk4
you need to remove front bumper to access 8 torx screws 4 hold radiator to front panel and 4 hold air con rad to main radiator it should take about one and a half hours
It does not have one. The mk4 fiesa has a hydraulic clutch.
On a Mk4 Ford Fiesta, the thermostat is typically located near the engine block, specifically in the housing where the upper radiator hose connects to the engine. It's positioned on the right side of the engine bay, near the front, making it relatively accessible for replacement. To reach it, you may need to remove the upper radiator hose and the thermostat housing cover.
If it is a mk4 onwards model it is on the front of the engine under the alternator sitting in the plastic housing
Whats wrong with it?
Only the hinge pins can be replaced without major bodywork as the hinges are welded to the doors and the frame.
how to change alternator on mk4 v5 golf