0
Prepare to be frustrated, as Mercedes did not make this easy. Remove the plastic outer housing located inside the engine compartment. There is a wire clip holding in the headlight bulb. push the top of this clip to the left and release it from the bracket. pinch both sides of the lower part of the clip (below the bulb) to remove them from the clip. Prepare to have your fingers hurt. Putting it back on, reverse the directions. You will probably drop the wire clip several times during the replacement process. The answer above was VERY helpful, however I found that if you disconnect the lamp from the wire harness before trying to remove the clip, it's not hard at all to remove the clip or to replace the clip after changing out the bulb. The passenger side was MUCH more difficult than the drivers side.
What else can I help you with?
How do you remove brake light 1998 slk 230 Mercedes?
To remove the brake light on a 1998 Mercedes SLK 230, first open the trunk and locate the light assembly. Remove the screws or clips securing the assembly, then gently pull it out from the body of the car. Disconnect the wiring harness from the back of the light assembly and replace the bulb if needed. Finally, reinstall the assembly by reversing the process.
Exploded view of Mercedes SLK-230 headlight assembly?
This would be something that is done by the manufacturer. You can do an image search in order to find this information.
How do you replace the driver side headlight low beam bulb on a 2007 Mercedes 230?
call car talk look it up on google.
What type of motor oil do you use for a 1998 Mercedes SLK 230?
Mobil one 0-40
What size wrench is used to remove oil filter cap from 1998 230 SLK?
To remove the oil filter cap from a 1998 Mercedes-Benz 230 SLK, you typically need a 27mm socket or wrench. It's advisable to use a ratchet for better leverage, as the cap may be tightened securely. Always ensure the engine is cool and use an oil catch pan to avoid spills.
How do you replace the tailight in a Mercedes 230?
Remove the trim panel from the inside of the trunk to gain access to the lamps.
1998 mbz slk230 turn signal flasher location?
Location of signal light control modual in 98 slk 230 mercedes
How do you add fluid to hydraulic pump in a 1998 Mercedes Benz slk 230?
To add fluid to the hydraulic pump in a 1998 Mercedes-Benz SLK 230, first locate the hydraulic fluid reservoir, typically found near the front of the engine compartment. Remove the cap and use a funnel to add the appropriate hydraulic fluid, ensuring you use the recommended type as specified in the owner's manual. Check the fluid level using the dipstick (if available) and add more fluid as needed, but avoid overfilling. Finally, replace the cap securely after adding the fluid.
Where to buy rebuild engines and transmission for Mercedes-Benz slk 230-class?
here to buy rebuild engines and transmission for mercedes-benz slk 230-class?
Where to buy rebuild engines and transmission for1997 Mercedes-Benz slk 230-class?
Where to buy rebuild engines and transmission for1997 mercedes-benz slk 230-class
How do you remove the engine cover on a 2005 Mercedes c 230?
From what I know, The cover must be held by screws or bolts ,but even tho since your vehicle is considered as high end it can only be removed by ASE CERTIFIED technicians by Mercedes Benz . They have special tools to remove them only at dealerships.
How do you replace the drive belts on an 1974 Mercedes sl?
how do you replace the drive belts on an 1974 mercedes 230
