0
What else can I help you with?
What size torx wrench to remove front calipers 1998 Monte Carlo?
The T60 is the size needed to remove caliper bracket.
What size oil filter wrench do you need for a 1998 Saturn SC2?
go to auto parts store and get the right filter for the Saturn then go to the filter wrench selection and find one that fits that is the style you like
What size wrench do you use to remove the water separator filter on a 2004 for super duty?
1-3/8 Combo wrench or socket
What size wrench to take gas filter off of 1994 Chevrolet s10?
You will need a 1" wrench to remove the one inside the Carb.
What size wrench does a 2007 cobalt oil filter need?
use a 1 and 1/4 inch socket to remove oil filter cap.
What size wrench is used to remove drain plug 1998 MB E320?
13mm for motor oil on E320
What size wrench is needed to remove pressure hose from power steering pump on 1998 Ford Windstar?
18mm
What size fuel filter disconnect tool do you need to remove the fuel filter on a 1997 Ford F-150?
an ordinary crescent wrench will work just fine
What size wrench to remove oil pan plug on 2012 Chevy Cruze?
24 MM OIL FILTER AND t40 torx FOR PLUG
What size hex wrench is needed to remove the front calipers on a 1998 gmc suburban?
its not a hex,,,it`s a torx t30 i believe
What is the size of the oil filter wrench for a 2008 Volvo c70?
The oil filter wrench size for a 2008 Volvo C70 typically requires a 36mm socket or an adjustable oil filter wrench. It's important to ensure that the wrench fits securely around the filter to avoid damage during removal. Always double-check the specific filter type and size, as variations may exist depending on the engine configuration.
How do you replace the fuel filter on a 1998 Chevy S-10?
The filter is located almost directly underneath the fuel door on the driver's side. Spray some WD-40 on the coupler that fits the fuel line and filter. Let sit for about 10 minutes. You need 2 wrenches to remove the filter on the coupled side or you WILL snap the line. The other side is just a latch. You just pinch in the little buttons and it should come right off. If the wrench on the actual fuel line seems to slip, use a crescent wrench or adjustable wrench. Same thing. I believe the wrench size for the fuel filter itself is 5/8 butI don't recall. Fit a wrench to size with the new filter before removing the old one. Reverse the procedure to install. Oh you will get a little fuel coming out when you remove the old filter. Put a pan or old bowl down to avoid getting fuel all over.
