To replace the bonnet release cable on a 2001 Corsa, first, open the bonnet and locate the cable's release mechanism. Disconnect the cable from the latch and remove any retaining clips or screws securing it to the body. Then, feed the new cable through the same routing, attach it to the latch, and secure it in place. Finally, test the release mechanism to ensure it operates smoothly before closing the bonnet.
how do you replace a drivers side mirror on a el ford falcon
To replace the bonnet cable on a Vauxhall Corsa, first, release the bonnet and secure it open. Then, remove the plastic trim around the release lever inside the vehicle to access the cable. Disconnect the old cable from the lever and the latch mechanism at the front, then install the new cable by reversing the disassembly steps, ensuring it is properly routed and secured. Finally, test the new cable to ensure it operates smoothly before reassembling any trim.
Open the bonnet. Remove the grill. Remove the screws holding the headlight in. Carefully pull the headlight out. Remove the cap on the rear of the headlight.
you need a small flat blade screwdriver. use your shoulder to prop the bonnet whilst you flick the metal clips on either end of the strut. or you could just use a long broom to prop the bonnet. the struts should pop off the ball. the new ones should just click on. done. note: the bonnet will be pretty heavy.
Open bonnet, remove anything in your way to the rear of the headlight (air ducts, battery, etc.), remove rear panel from the light, replace bulb, use small hands.
how to remove inhibitor switch on ef falcon
Just changed mine it's simple just pop the bonnet and remove the retaining wires then take the appropriate bulb out and replace easy
To replace the distributor cap on a 1996 Ford Falcon Futura, you first need to remove the screws holding it in place. Then pull the old cap straight off. Replace the new one, in the opposite order of removing the old one.
Flush engine. Allow car to idle. Remove sump plug and let it drain. Remove filter with jaw type oil filter wrench. Replace existing filter with a quality z9 filter, mostly used on ea falcon.
I would contact Falcon by email. Sales@falcon-airguns.co.uk and ask them.
1 Open the bonnet 2 On the bottom of the emblem there is a small pin, use a pair of pliers to remove it. This will cause the old emblem to spring out. 3 Put the new unit in from the top of the bonnet. 4 On the underside twist the new unit into the locked position. Thats it.