The rear window wiper arm/cover is an integral, cast in one plastic unit. The metal wiper blade frame snaps into a flexible channel cast into the underside, centre of the arm/cover.
To replace, just lift the arm up and away from the glass with your right hand, grasp one side of the metal blade frame with your left fingers (or pry with a smooth screw driver) pulling away from the arm/cover toward the glass. The blade should pop out easily. Carefully centre the new blade in the channel and push it straight in. Don't push on the rubber part, push on the metal blade frame to avoid distorting the arc of the rubber blade clips. If the blade isn't centred in the arm/cover repeat the process.
That's all there is to it.
You access it from under the hood. Facing the engine compartment you have to remove the plastic panel underneath the passenger side windshield wiper blade. Remove the passenger wioer blade arm, then remove the 4 or so plastic tabs. Then remove the plastic caps closer to the windshield there are screws underneith remove them then remove the ruber seal over the portion of the panel it is covering. There is another plastic cover underneith that one and that is where the filter goes. Hope that helps.
Not sure what you mean by "windshield wiper cover," however if you're asking how to remove the rubber blade from the plastic frame - be careful. The end caps do come off but its not recommended. I recommend simply replacing the entire wiper blade. See videos on link below.
Be sure to cover the blade with a proper blade cover and remove the battery.
First remove the plastic cover at the fixed end, this will allow you to lift the wiper arm up and you can then unclip
under the steering wheel, you have to remove the plastic cover and the metal bar. you will find a yellow blade fuse.
Take a stanley blade and take it all the way round the plastic on the light it will then remove.. take a bit of bonding gliue and put the new plastic on
The fuse box located under the hood (sits on top of the battery) has a cover. Remove the cover and turn it over. The diagram is molded into the plastic. Not sure about the fuse box located on the passenger side of the console.
A black plastic cover snaps off from the base of the wiper arm, once removed, the wiper blade can then be unlocked and removed to be replaced. For more information on car:- http://www.autopitch.com/blog/
Australian R/H Drive - there are 2 batteries under a cover - under the drivers seat. Cover is held in place by a plastic 'bung' with a blade top - twist 90deg & remove. Cover slides forward.
If there is another cover then you can remove it. If the plastic covering is the only cover on the cheese and it is kept off there is a good chance it will go bad earlier then it should.
you take it to a dentist
There are no 'clips'. The filter is on the passenger side under the plastic cover just below the wiper. Remove plastic cover's weatherstrip; Remove plastic cover's center retaining bolt; Remove plastic cover's plastic passenger side 'screw'; Lift out passenger side cover; Filter is in the well. Pull it out. Installation is reverse of removal.