To remove the dashboard of a 1993 Mazda 323, first, disconnect the negative battery terminal for safety. Then, remove the screws and bolts securing the dashboard, which are typically located around the instrument cluster, beneath the steering column, and along the edges. Carefully detach any wiring harnesses and clips connected to the dashboard. Once everything is disconnected, gently pull the dashboard away from the frame, being cautious not to damage any surrounding components.
how do remove the brake drum on a 1991 mazda 323
The flasher unit on a Mazda 323 is located on the end of the flasher lever. Remove the lower steering column to bring the unit to view.
To remove the speedo head from a 1989 Mazda 323, first disconnect the negative battery terminal for safety. Then, remove the dashboard panel to access the instrument cluster. Unscrew the screws holding the speedo head in place, disconnect the speedometer cable, and carefully pull the speedo head out of the cluster. Reassemble the dashboard once the speedo head is replaced or serviced.
The wreckers perhaps.
i am sry to tell you that the arm Mazda 323 1993 cost $40,000 to repair but u ain't lucky cuz the arm Mazda 324 1994 cost $1 to repair
where is the flasher unit on the sp20
The speedometer cable on a 1987 Mazda 323 is located on top of the transmission and travels up to the dashboard. It helps the vehicle's computer monitor speeds constantly.
The Mazda 323 of that time from had a 1600cc engine but that isn't going to effect the issue of where to get a wiring diagram. Haynes makes a manual for the 1990-1994 Mazda 323. If you have a 1986-1989 Mazda 323, you will need to get a FSM (Factory Service Manual).
replace headlight on mazda sp20
it is to the left of the engine beside your belt.
With an uncle and a hammer.
In the 2002 Mazda 323, the daytime running light (DRL) relay is typically located in the fuse box under the dashboard on the driver's side. You may need to remove the cover of the fuse box to access the relay. Refer to the vehicle's owner's manual for specific diagrams and locations if needed.