On the left and right sides of the radio there are four rubber tabs, remove these with a pocket knife or small flathead screwdriver, they will pop out with little force.
After you remove the rubber tabs, there are four holes. Take a wire coat hanger and cut off the two ends making a "U" shape. Place the ends of the U-shaped hangers into the holes. Behind the holes are spring clips that hold the radio in place. Push the hangers in about 1/4 to 1/2 inch so that it will depress the spring clips on each side. Apply a little outward pressure and pull gently this should release the spring clips from their position and you should be able to pull out the radio.
You then unhook the antenna wire, two wiring harnesses, and the ground wire from the rear of the radio. That's it. :)
If anyone has the color code information I would be grateful if you could post them. I have only found conflicting information on the net so far.
view website www.cdplayerrepair.com/remtips/vigor_rem.htm
you will notice small holes at each corner of the stereo face, you just need top poke something into all 4 holes to release the unit
You can use the 1990 stereo in your 1992 Accord, but the 1998 will not bolt in the correct way.
MAYBE WAL-MART IF NOT A STEREO INSTALL SHOP
Found this on another FAQ site: http://www.installdr.com/InstallDocs/Toyota/PDF/869005.pdf complete removal and install of a new deck....
That should be the factory amp for your car stereo
u have to go to the shop and buy it and pay the shop to install it
ITs Behind Your stereo its sitting flat its only 2 screws To remove but you need to remove The carpet From The sides And you Will see it !
yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.
The Apples in Stereo was created in 1992.
Were is the egr on a 1992 mazda protege
NO, but the entire wheel assembly will have to be removed.