answersLogoWhite

0

Some vans don't hav a fan clutch but electric fans. If yours does have one, simply remove the 4 bolts holding the fan on then take the bolts out of the clutch. If it has just one big nut a special tool is required.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you remove fan from 1993 ford econoline e150 4.9liter 6 cylinder?

You need to rent or buy a fan clutch removal tool kit. you need to remove the fan and clutch as one before you can separate the fan from the clutch.


How do you find carborator in 95 ford econoline?

The engines are fuel injected on the 1995 Ford Econoline vans so there is no carburetor


How do you reset fuel shut-off switch on a 1995 ford econoline van?

how do you reset the fuel cut-off shut switch on a 1995 ford econoline van?


How do you hot wire a 1995 Ford econoline 250?

how to hotwire ford 95 econline


Where is the horn on a 1995 Ford Econoline E350?

The horn on a 1995 Ford Econoline E350 is located in the rear cargo area below the floorboard. It is almost directly in the center of the rear near the back bumper.


How do you fix the door cables on a 1995 ford econoline?

diagram for replacing cable to door handle latch 1992 for econoline van


Where does the clutch fluid for 1995 ford escort wagon?

On a 1995 Ford Escort : The brake fluid reservoir is also the clutch fluid reservoir


1995 5.7 Triton V8 - What is hoursepower and torque. 1995 Ford Econoline RV. What is the reputation of the engine?

Ford doesn't make a 5.7triton.


How do you remove a heater core from a E350 Ford Econoline?

Sell your Ford junk its not the only problem you will have.


Where is the 1995 Ford e250 fuse box diagram?

2002 ford econoline van fuse box diagram


Does a 1995 Ford Econoline have a computer?

Yes, it has a PCM, which is what most people call a "computer".


1995 for econoline van how to remove ignition switch?

To remove the ignition switch from a 1995 Ford Econoline van, start by disconnecting the battery to ensure safety. Next, remove the steering column covers by unscrewing or unclipping them. Locate the ignition switch on the steering column, disconnect the electrical connector, and then remove the mounting screws to take out the switch. Finally, reverse the process to install a new ignition switch if needed.