bumper is connected to fenders by several bolts that you can see if you open the hood and look toward the area where the nose and fender join.
http://www.bfranker.badz28.com/fbody/repaint.htm this has everything you need to know to remove bumper cover just ignore the stuff about repainting unless that's what u plan to do
To remove the front bumper cover on a 1993 Camaro, first, ensure the vehicle is parked on a flat surface and disconnect the battery. Then, remove the screws and clips securing the bumper cover, which are typically located in the wheel wells, under the front fascia, and along the top edge near the grille. After removing all fasteners, gently pull the bumper cover away from the vehicle, taking care not to damage any attached components. Finally, disconnect any wiring for fog lights or turn signals if equipped.
We have detailed instructions on our enthusiasts website. The bumper cover is fairly easy and we have pictures to help. www.trailvoy.com
Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.
REMOVE TWO TOP BOLTS ON HEADLAMP ASSY. THEN REMOVE BUMPER COVER, THATS RIGHT THE BUMPER COVER, THEN REMOVE TWO BOTTOM BOLTS
in the valve cover
To remove the rear bumper cover on a 1993 Ford Taurus wagon, the lights need to be disconnected in the rear. Once all electrical connections are disconnected in the rear, remove the taillights and the fuel filler overflow hose. Remove any nuts and bolts holding the bumper cover on. Using needle nose pliers, pop the push pins around the bumper cover upwards. Slowly pull on the bumper to remove it.
Paint stripper works well, but cover plastic and rubber parts because paint stripper will destroy them.
rip it off
,
1. If needed raise vehicle and support it on Jack stands 2. Remove the retaining screws in the wheel wells and along the upper and lower edges of the bumper cover. Remove the tail light housings. Remove the rear trim plate and pull luggage compartment trim out for access then remove the remaining bumper cover retaining screws. Remove the bumper bolts 3. On station wagons remove the rear window washer fluid reservoir for access to the bumper retaining bolts. The remaining bumper bolts are accessible from below 4. Pull the bumper and cover assembly out and away from the car
To remove the rear bumper cover on a 2006 Trailblazer, start by disconnecting the negative battery cable for safety. Next, remove the screws and bolts securing the bumper, typically found under the rear taillights and along the bottom of the bumper. Carefully pull the bumper away from the vehicle, detaching any clips or connectors, and ensure to check for any wiring that may need to be disconnected. Once everything is clear, you can fully remove the bumper cover.