Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.
Behind the front bumper
Transmission cooler is in front of the a/c condenser behind the front bumper. It is the smallest radiator looking component behind the front bumper
throw a hand grenade at it
To remove the front bumper cover on a 2004 Hyundai Santa Fe, first, ensure the vehicle is parked on a flat surface and the engine is off. Begin by removing the screws and clips located at the top and bottom of the bumper, as well as any wheel well screws if applicable. Gently pull the bumper away from the vehicle, disconnecting any electrical connectors for fog lights or sensors if present. Finally, carefully detach the bumper cover from any additional mounting points before fully removing it.
To remove the front bumper on a Hyundai Getz, start by disconnecting the negative battery terminal for safety. Then, remove any screws or clips securing the bumper, typically located under the wheel arches and along the top edge of the bumper. Carefully pull the bumper away from the body, making sure to detach any wiring harnesses for fog lights or sensors. Finally, gently lift the bumper off the mounting points to complete the removal.
To remove the front bumper of a Hyundai Excel, start by ensuring the vehicle is parked on a flat surface and the ignition is off. Remove any screws or bolts securing the bumper, typically located in the wheel wells and under the front lip. Carefully pull the bumper away from the body, disconnect any wiring for fog lights or sensors, and lift it off. Always consult the vehicle's manual for specific instructions related to your model year.
How much does it cost to replace the front bumper on a 2013 hyundai accent
how to remove front bumper on citroen berlingo
how to remove front bumper 2002 Impala
its located behind the plastic "wall" that is between the right bumper and the right front wheel. if you remove the screws you will find the pump and the base of the windshield wiper fluid container.
The Washer pump is on the bottom of the reservoir - but you have to remove the front bumper to access it, so be sure it it sht pump and not the switch. Yes I said you have to remove the front bumper to access it. You can go to the very helpful Hyundai web site http://www.hmaservice.com create a login and see schematics. It's a little tricky, but with trial and error you can see just about everything.
The 2012 Hyundai Santa-FE has 59.5 in. of front shoulder room.