0
What else can I help you with?
Is the axle on a 1991 tracker floating How do you remove it to replace the outer seal?
The axle on a 1991 Suzuki Tracker is a semi-floating design, meaning it has a shaft that is supported at both ends but relies on the wheel hub for additional support. To remove the axle to replace the outer seal, first, remove the wheel and brake components, then disconnect the axle from the wheel hub and the differential. Finally, pull the axle out of the housing, taking care to replace the outer seal before reassembling everything.
How to replace 2001 buick regal license plate bulb?
Open the trunk lid looking inside the trunk lid remove the 8 or9 plastic wingnut that hold the outer panel to the trunk, replace the lights and reinstall the panel in reverse order.
How do I replace the fan motor on my AC unit?
To replace the fan motor on your AC unit, first turn off the power to the unit. Remove the outer cover and locate the fan motor. Disconnect the wiring and remove the screws holding the motor in place. Install the new motor, reconnect the wiring, and secure it with screws. Finally, replace the outer cover and restore power to the unit.
How do you replace a headlamp for a 1994 Chevy G20 Van?
Remove the outer plastic trim to reveal the lamp frame holding screws. remove the frame and the lamp comes out the front
Where is the fuel pump located on a 1994 Saturn SL2 is it in the tank or in the line to the tank?
Its in the tank, as 99% of GM cars are. In order to replace you will have drop the tank, remove the outer safety ring, disconnect the wiring harness, and remove pump, pretty simple job if yo know what your doing.
How do you replace front wheel bearing Honda odyessy?
Jack up the Odyessy. Remove the wheel and the brake caliper. Take the brake rotor off. Remove the axle nut cover, and the cotter pin. Remove the axle housing. Replace the inner and outer bearings as well as the races.
How do you replace inner tie rod ends on a 1992 Toyota Camry?
Remove wheel and disconnect outer tie rod from lower control arm. Clearly mark original position of outer tie rod end on shaft and remove outer tie rod end. Remove rack and pinion boot revealing. Unscrew inner tie rod from rack and pinion assembly.
How do you replace indicator lens on a Volkswagen Passat 1.9TDI?
hi thereprise the mirror glass out and remove the outer casing and also remove the backing, there are 2 small screws at the bottom of the mirror remove them and replace the lens, dont worrie about which way you connect the mirror glass electrics as it is a curcuit,good luck
Do you have to remove the shaft from the automatic transaxle in order to replace the outer CV boot on a 1990 Grand Am?
You do not have to remove it, but doing so will make the boot replacement a whole lot easier. Being able to clamp the axle in a vice is much nicer than trying to work around the front suspension pieces.
How do you repair outer tierod end?
Remove old one and replace. Several specialty tools are required. The last step is a front end allignment.
How do you Change Brake and Rotors on a 2004 Grand Prix?
Remove wheels Loosen 2 Caliper mounting bolts Remove only one to allow caliper to swing away from rotor Remove rotor Remove outer brake pad Use "C" Clamp to retract piston into caliper body Remove inner pad Replace inner and outer brake pads Replace rotor Resecure brake caliper BE SURE TO PUMP BRAKE PEDAL PRIOR TO MOVING VEHICLE TO SET PADS AGAINST ROTOR
How do you replace tie rods on 2000 neon?
There are two types of tie rods on a 2000 Dodge neon. The outer-tie rod connect to the inner-tie rods which mount to the steering rack. The outer units are threaded on to the inner- tie rods. Remove them by spinning it counter clockwise. Take a special tie rod socket to remove the inner-tie rod. Replace the units.
