0
OK, the problem is - you have to use sufficient brute force to pull it off, but not so much that you break the plastic! There are 2 bolts, which are visible and obvious when you open the boot. Remove these. There are also a number of push-in lugs which are now holding the lens cluster on. The chances are that they are jammed tight, like mine were. Try rocking the lens cluster around to get a bit of a gap around the edge. Dont try to prise it off, as you will break the plastic, and it will be expensive. Try to wedge in some cardboard around the rim on the outboard side of the lens, to hold it away from the car body as much as possible. Then, get your fingers under the flange where you removed the 2 bolts - its the only part you have to pull on . Pull steadily and hard, and it should pop off. Dont hit it!
What else can I help you with?
How do you change a trunk light in Nissan Maxima 2002?
To change the trunk light in a 2002 Nissan Maxima, a person will need to unscrew the cover over the light. Then they can remove the old bulb and replace with a new one. Then screw the lens cover back on.
How do you change tail light lens 91 Nissan pickup?
To change the tail light lens on a 1991 Nissan pickup, start by removing the screws or bolts securing the tail light assembly to the vehicle. Once loose, gently pull the assembly out from the body. Disconnect the wiring harness by pressing the release tab and remove the old lens. Install the new lens by reversing the process, ensuring it is securely fitted and the wiring is properly connected.
How do you replace the front turn signal bulb located on a 1993 Nissan 240SX?
one screw holds the light on, take it off and spin the light lens holder to remove the bulb
How do you remove the back lens on a 1992 Nissan pick-up to replace the bulb?
Hey Jerry==There are bolts that hold the light assy on. Some are hidden pretty good. GoodluckJoe
How do you change the third brake light bulbs on a 1995 Chevy 2500?
Remove the two screws that hold the lens on, remove the lens and change the bulbs.
How to change an MR16 bulb fast?
You will need pliers to remove the wire strip that keeps the light in the socket, then remove the lens. Carefully remove the bulb making sure there is not power in the light then replaces the bulb and reattach the lens and wire.
How do you remove third brake light s10?
Remove the two screws in the lens. You can remove the entire assembly once you do this.
How do you remove the cover for the high brake light in a 2005 Chrysler town and country?
The lens assembly is held in with two screws. Remove those and the lens will pop out.
How do you replace a dome light on an 86' Chevy Celebrity Eurosport 2.8L?
To replace the dome light bulb first remove the lens. If you gently squeeze the sides of the lens it will come out. Remove the old bulb, put in the new bulb. The lens snaps back in place.
How do you remove the tail light lens on a 2002 Lexus LS430?
To remove the tail light lens on a 2002 Lexus LS430, first, open the trunk and locate the access panel behind the tail light assembly. Remove any screws or clips securing the access panel, then gently pull it away. Disconnect the electrical connector from the tail light assembly, and remove the screws holding the tail light in place. Finally, carefully pull the tail light assembly out, and the lens can be detached from it.
How do you remove tail light box in jeep wrangler?
Remove the lens, and the mounting screws are at the back of the box.
How do you remove the lens to a headlight on a 2000 Grand Jeep Cherokee?
Not possible. You have to remove the whole light assembly.
