0
To remove the rear shock absorbers on a 2001 Aurora, first, safely lift and support the vehicle using jack stands. Then, locate the upper mounting bolts inside the trunk and the lower bolts at the base of the shock. Remove the lower bolts using a socket or wrench, followed by the upper bolts, and carefully pull the shock absorber out. Repeat for the other side if necessary.
What else can I help you with?
Are struts or shock absorbers on a 2001 Chrysler LHS?
A 2001 Chrysler LHS has suspension struts.
Does a 2001 ford explorer have shocks or struts?
shock absorbers front and rear
How do you change the front shock absorbers on an 2001 Chevy truck and what tools do you use on the top of the shock?
very carefully.
Is there struts on a ford explorer 2001 sport track?
No ( shock absorbers front and rear )
Is there struts on a 2001 Ford Explore sport trac?
No ( shock absorbers front and rear )
Where is the transmission fluid drain plug for a 2003 flstf?
My 2001 FLSTF is between the 2 shock absorbers.
How many hours to remove a transmission from a 2001 Oldsmobile Aurora?
6
How do you remove the dash face plates on a 2001 Oldsmobile aurora?
you cant! impossible.
How do you install front shock absorbers on a 2001 Acura?
It does not have shocks on the front, it has struts. You better know what you are doing when replacing struts or you can get seriously injured. Take it to a pro.
How do you change water-pump in a 2001 Aurora 3.5?
You will need to remove the water from your 2001 Buick Aurora cooling system. Remove the water pump return hose. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
How do you disable the air compressor for load levelling shock absorbers on 2001 Pontiac Montana?
To disable the air compressor for the load leveling shock absorbers on a 2001 Pontiac Montana, locate the air compressor under the vehicle, typically mounted near the rear axle. Disconnect the electrical connector or remove the fuse related to the compressor from the fuse box to stop its operation. Additionally, you can release the air from the shocks by disconnecting the air lines, but ensure to do this carefully to avoid damaging the components. Always consult the vehicle's service manual for specific instructions and safety precautions.
Where is the location of the crankshaft sensor on 2001 aurora?
Aurora 3.5 - the sensor is on the front of the engine, on the right side, up behind the starter. You can see it from the bottom looking up, but you have to remove the starter to get it out. The Aurora 3.5 has a single dual sensor. The Aurora 4.0 has two separate sensors.
