answersLogoWhite

0

If this is an automatic transmission, the pan must be removed in order for the fluid to drain. In addition, there may be a plug in the torque converter to facilitate fluid removal from it. When removing the pan for a fluid change, the standard procedure is to remove all but a few of the bolts holding the pan on, leaving several at opposite corners finger-tight. When ready with a pan in place to catch the fluid, these are carefully removed in turn, allowing the pan to drop down at one corner, draining the fluid. Once most of the pouring has stopped, the few remaining bolts are slowly removed, allowing removal of the pan and access to the filter. NOTE: If all you need to do is drain a small amount of fluid due to overfill, it may be possible to use a length of tubing fed down through the filler tube and siphon it out. jb

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where do you add transmission fluid to a 1965 Mustang?

In the fluid chamber


What transmission fluid is recommended for a 1965 Mustang 280 automatic?

Type F


What kind of transmission fluid in a 1965 Ford Mustang 3 speed?

80W-90


What kind of fluid in a 1965 Ford Mustang 4 speed transmission?

A 1965 Ford Mustang with a 4-speed transmission typically uses Ford Type F automatic transmission fluid or a high-quality manual transmission fluid designed for vintage vehicles. It's important to check the owner's manual or consult with a specialist to ensure the right fluid is used for optimal performance and longevity. Using the incorrect fluid can lead to shifting issues or damage to the transmission components.


HoW much transmission fluid does a 1965 mustang take?

If it's a manual 4 speed 289, 3 1/2 pints


What transmission fluid do you use in a 1965 mustang 4 cylinder?

Ford automatics of that era use Type F fluid. Incidently, so does the power steering unit.


Did ford install 5 speed transmission in a 1965-66 mustang?

no


Why would a 1965 Mustang not start until the third try and then when attempted to turn off it stays running until you disconnect the starter even with the key out of the ignition?

I am new to owning a 65 Mustang, but I am 99% certain it is because you are low on transmission fluid. This happened to me just recently, and as soon as I put in transmission fluid (it turned out there was a leak), it stopped doing that.


What fluid is used in a 1965 impala convertible pump?

Automatic transmission fluid


What is the timing for a 1965 mustang 200?

6 degrees BTDC with manual transmission 12 degrees BTDC with automatic transmission


Where do you add transmission fluid on a 1965 ford galaxy 500 with a 390?

You add transmission fluid at the exact same place you check the fluid level. Do not overfill!


What are the timing specs 1965 six cylinder mustang?

6 degrees BTDC - manual transmission 12 degrees BTDC - automatic transmission