To replace the headlight on a 1986 Honda Spree, first, remove the front cowl by unscrewing the screws securing it in place. Once the cowl is off, disconnect the wiring harness from the back of the headlight bulb. Replace the old bulb with a new one, ensuring it’s securely connected, then reattach the cowl and screws. Finally, test the headlight to ensure it’s functioning properly.
poke it wear it counts
Buy a Chiltons/Haynes Manual. Simple. Easy. Idiot Proof. Available at your local auto parts store.
Check wiring, fuse, and all connections. Most likely have to replace the sensor.
Probably no...
Follow the link this will help.
To change the headlight bulbs on a 1986 Cadillac Eldorado, first, open the hood and locate the headlight assembly. Remove the retaining ring or clips that hold the headlight in place, then pull the headlight out gently. Disconnect the wiring harness from the back of the bulb, replace the old bulb with a new one, reconnect the wiring, and reassemble the headlight assembly by securing it with the retaining ring or clips. Finally, test the new bulb to ensure it works properly.
A clymer manual that is appropriate for your Honda model.
Yes, should be the same block
`86 & `87
In a 1986 Trans Am, the isolation relay for the headlight doors is typically located in the engine compartment, near the driver's side fender, often mounted on the relay panel. There are two relays in the headlight door circuit: one for the opening mechanism and another for the closing mechanism. This setup allows for the proper operation of the pop-up headlight doors.
60ml
Genuine Honda A/T fluid. Purchase it at your local Honda Dealer. Do not use anything else.