0
Take the old line to the repair shop and buy new, pull the line out of the tank, get the fuel filter out of the tank. Cut the end of the new fuel line to a 45 degree angle and start putting it in the hole in the fuel tank. Grab the line thru the filler neck (use needle nose pliers) and pull about 5-6" of the line thru, cut the 45 degree angle off and make it 90 degrees and attach the fuel filter. Put all the line you pulled thru into the tank. Cut the remainder of the line to length and attach it to the carburetor.
What else can I help you with?
Echo weedeater primer bulb wont fill?
cracked gas line, cracked bulb, or weedeater out of gas
How much oil do you add to 1 gallon of gas for a weedeater?
Look on the Gas cap of your weedeater. It should tell you the gas to oil ratio. If its not there try looking in the manual or online.
How do you replace a stihl weedeater head?
sthilweedeaterhead number f5556
Can you replace a diesel engine with a gasoline engine?
you can but you have to replace gas lines and tank and some sensors
How do you replace a Weed eater FL 20 flex shaft?
i need to replace the flex shaft in my weedeater. how do i do it?
What is the correct ratio of gas to oil for weedeater leaf blower B175OLE?
40to1
How do you remove gas tank to replace gas lines on pe550 22cc weedeater edger?
If you look on the blade side of the edger you will see six screws on a metal plate,Do not remove them. There are three holes under the plate that has three plastic plugs in them,remove with long needle nose pliers and then you will see three screws. Loosen them just enough to remove tank. Good luck.
How do you replace the trimmer head on your Weedeater model WT3100?
The manual can be found at the link below.
What is gas oil ratio mix for shindaiwa T-261 weedeater?
50:1
How do you replace gas lines on a 1998 chev lumina 3.8 l?
Very Carefully
How do you reload a single string weedeater?
pop the spool out wind string in direction of arrow, replace
How do you replace head on husqvarna weedeater?
To replace the head on a Husqvarna weedeater, first, ensure the engine is off and remove the spark plug wire for safety. Use a wrench to hold the spindle in place while unscrewing the old head by turning it counterclockwise. Align the new head with the spindle and screw it on clockwise until secure. Finally, reattach the spark plug wire and test the weedeater.
