0
What else can I help you with?
Where is the camshaft position sensor located on a 1999 Oldsmobile Intrigue and how do you replace it?
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
Show the location of camshaft position sensor for 2002 Oldsmobile bravada?
show location of camshaft position sensor for 2002 Oldsmobile bravada.
How do you replace a camshaft position sensor on a 90 Oldsmobile 98?
It is pretty technical and special tools are needed. Take it to a garage.
How do you replace crankshaft position sensor Oldsmobile 1988 ninety-eight?
You have to dismantle the entire engine,,,NO YOU DO NOT ITS JUST YOU HAVE TO DRAIN THE OIL TAKE THE OIL PAN OFF AND GET THAT DANG SENSOR TAKEN OUT THEN REPLACE IT!!
Where is the outside temperature sensor located on a 1998 Oldsmobile Regency?
I believe it is located underneath the front bumper.
Where can one find Throttle Position Sensor - TPS recommended volt settings for 1990 Regency 98 Oldsmobile?
I would recommend getting the Haynes repair manual for your car and all that information is there.
Where is the location of outside temperature sensor on a 1993 Oldsmobile Regency?
On a 91 regency it's located in the center under the hood near the hood latch assembly!! Dave
How do you replace the throttle position sensor in a 98 Olds intrigue?
The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.
How do you set a tpi sensor on an 1985 Oldsmobile regency 3.8 motor?
some tps sensor are none adj.most gms others adj. .5volts to 1volt
Where is the Camshaft Position Sensor located in the 1996 Oldsmobile Achieva?
The Camshaft Position Sensor is located behind the Power Steering Pump.
How do you replace the throttle position sensor on a 97 Nissan altama?
how to replace the throttle position sensor on a 97 nissan altama
How do you replace replace the camshaft position sensor?
In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.
