To replace a front side light on a Nissan Serena, start by opening the hood and locating the headlight assembly. Remove the screws or clips securing the assembly, and gently pull it forward to access the light bulb. Disconnect the wiring harness from the bulb, twist the bulb counterclockwise to remove it, and then insert the new bulb by twisting it clockwise. Finally, reassemble the headlight assembly, ensuring it is securely fastened, and test the new bulb to confirm it works.
shogun side light bulb
Take it to the garage
You have to pull off the front bumper 1st. Then after you pull off the front bumper, then you have to disconnect the whole light from the car. After that you can replace the bulb.
Open the hood as the light bulb pop into the back side of the lens
I took a few screws out of the front wheel well mud guard behind the marker light and reached in through there to remove and replace the side marker light.
The passenger side front marker light can be access from the back of the light. Take hold of the connector, push in and turn at the same time. The light will come out. Reverse the process to install the new light.
On my 2002 Nissan Xterra I had to remove 4 screws from the front bumper and wheel well and then I was able to get to the back side of the side marker light and remove the nut in order to get to the light bulb.
flasher will not flash when circuit is open or shorted replace left front turn signal bulb
On my 2002 Nissan Xterra I had to remove 4 screws from the front bumper and wheel well and then I was able to get to the back side of the side marker light and remove the nut in order to get to the light bulb.
there is a fatty that comes and does it
On my 2002 Nissan Xterra I had to remove 4 screws from the front bumper and wheel well and then I was able to get to the back side of the side marker light and remove the nut in order to get to the light bulb. i don't need to change just the bulb. The entire light assembly must be replaced. The reflector is broken. i cannot get wires to release.
There's one screw on top of the parking light in the engine compartment that you need to remove, then it should come right out.