answersLogoWhite

0

The governor is behind a cover on the side of the tranny, the cover is held in by 4 bolts, undo the bolts ,take the cover off, then turn the governor counter clock wize as you pull it out.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Why is 1993 Lexus LS 400 is stalling?

1995 lexus ls 400 transmission get hot slow frist gear


How many gears in a turbo 400 transmission?

There are 3 foreward gears and 1 reverse gear.


What is the Gear ratio for a 1974 Pontiac Firebird Formula 400 T Code with TH400 Transmission?

3:42


Why would the transmission start in third gear in 1994 ls 400?

Guessing that the power to the transmission module is lost. Some manufacturers make available a "limp home" mode that reverts to third gear take off if the electronics are lost. In other words, if you unplug the computer harness from the transmission, the transmission will remain in 3rd gear so you can drive it to a repair shop.


Your turbo 400 transmission won't go into gear?

1960 camaro sitting for 10 year in garage damage engine fix


What are the causes for a Turbo 400 transmission to drive-in low gear and then it wouldn't shift to read highlight the tranny slipping?

The tranny slipping


96 polaris sport 400 kicks out of forward gear have adjusted linkage and changed fluid as manual suggests?

Gears in transmission are bad .


Why does a overdrive light flash on a Mercury Mystique?

The band that controls second and fourth gear has failed. Usually about a $400 repair at a transmission shop.


Can you replace a Chevy 3-speed manual transmission with a turbo 400 automatic?

Yes but do to the 400 Turbo Trans being much longer you will need a shorter drive shaft


How much does it cost to replace a 3rd gear synchro in the transmission in a 92 jeep wrangler?

For a shop to do it I would expect 5-800 dollars, buying a used transmission is most times cheaper. Used trans about 400-550$ To do it yourself around 250-300 depending on where you buy the kit. I am assuming you want to replace all of the synchro's at the same time, that's not something you want to do more than once.


Where do you change the transmission fluid on a 2007 Honda rancher 400 ATV?

To change the transmission fluid on a 2007 Honda Rancher 400 ATV, locate the drain plug on the bottom of the transmission case and remove it to allow the old fluid to drain out. Once drained, replace the drain plug and remove the fill plug located on the side of the transmission. Use a funnel to add the recommended transmission fluid through the fill hole until it reaches the proper level. Finally, replace the fill plug securely.


How much is an average cost to replace or rebuild a transmission valve body for example my car is 1998 Nissan Quest?

The average cost to replace a transmission belt line is approximately $600. The average cost to rebuild a transmission valve line is $400. Rebuilding the valve body is dependent upon several different factors.