Step one.
Wash the inside of your wheel arches, it's not essential but it will make this job a whole lot more pleasant (and if you do wash there every spring, help extend the life of your car)
Wait over night or move the car to a dry place rather than kneeling in the puddle you just made.
REMOVAL & INSTALLATION Front Turn Signal and Parking Lights CRV MODELS 1996-2000
1. Turn the steering wheel in the opposite direction from which the bulb is to be removed.
2. Using a flat blade screwdriver, remove the fasteners securing the wheel arch liner behind the headlight and pull back on the wheel arch liner. Et voila the back of your side lights and indicators is instantly accessible.
3. Remove the bulb socket from the light assembly by turning it counterclockwise
4. To remove the turn signal/side marker bulb, just pull the bulb straight out of the socket.
6. Installation is the reverse of the removal procedure.
How much easier was that? My condolences to the person who posted the original answer ( see discussion)
Now relax, confident in the knowledge that you have saved yourself some garage fees.
how do you replace a honda crv licence plate bulb on a 2004
No, they are on seperate circuits.
To change the front signal light bulb on the 1999 Honda CRV, pry up the fender fastener to expose the bulb socket. Twist the bulb socket 90 degrees and remove from the assembly. Turn the burnt bulb counterclockwise and pull out. Replace with new bulb.
how hard is it to replace a rear wheel bearing 1999 Honda crv. this crv does not have rear axle's in it. thank you
how much does it cost to replace brakes rotors on honda crv
The heater in the CRV Honda is not working . How do I fix this
How to replace glass only on 2003 Honda CRV Passenger side mirror
the inside, there's a panel underneath, unfortunately you have to manually dislodge the interior directly on the inside of the lightAdded: WHAT BULB ARE YOU ASKING ABOUT?
Open the hatch - remove the protective cover from the housing - twist out the bulb holder - remove and replace bulb - re-install in the reverse order.
Don't understand what is meant by "light bulb lock."
honda crv 1997 rear wiper blade should be 11", 13" is too big
Youtube has a video showing how to replaced the rear pads for a 2003 crv (02 crv is the same as the 2003 crv). At youtube type in 2003 Honda crv brake change. The video is very good.