0
What else can I help you with?
How do you replace an alternator belt on a 1987 Cadillac Brougham?
To replace the alternator belt on a 1987 Cadillac Brougham, start by disconnecting the negative battery terminal for safety. Then, locate the alternator and loosen the adjustment bolt and the pivot bolt to relieve tension on the old belt. Remove the old belt and install the new one, ensuring it is properly seated on the pulleys. Finally, adjust the alternator to create adequate tension on the new belt, tighten the bolts, and reconnect the battery terminal.
How do you replace a heater core in a 1987 Cadillac Brougham?
Try the repair tips on the Autozone web site.
How do you replace the rear wheel bearings on a 1987 Cadillac Fleetwood Brougham 5.0?
They are pressed in the axle. Take it to a garage.
Does a 1987 Cadillac brougham have front coil springs?
yes front coil springs with front shocks on a 1987 cadillac brougham rear wheel drive
Is there a trunk light on a 1987 Cadillac Brougham?
yes
How do you tighten fan belt on 1987 Cadillac brougham?
To tighten the fan belt on a 1987 Cadillac Brougham, first, locate the alternator, which is typically where the belt tension is adjusted. Loosen the bolts holding the alternator in place, then manually pull the alternator away from the engine to increase belt tension. Once the desired tension is achieved, retighten the bolts securely. Finally, check the belt for proper tension by pressing down on it; it should have about half an inch of give.
How many gallons of gas does a 1987 Cadillac Brougham hold?
20
What do the 1987 Cadillac Fleetwod brougham starter look like?
where is the starter to begin with
Will 22 inch rims fit your 1987 Cadillac Brougham?
Not without modification
What size speakers are in a 1987 Cadillac Brougham?
4" round in front and 6x9 in back
How do you find a detailed diagram 1987 Cadillac Brougham steering column?
Try e bay.
What bolt pattern is a 1987 Cadillac brougham?
The 1987 Cadillac Brougham has a bolt pattern of 5x5 inches (or 5x127 mm). This means there are five bolt holes spaced 5 inches apart from each other in a circular pattern. This bolt pattern is common among various GM vehicles of that era. If you're looking to replace wheels or tires, it's essential to ensure compatibility with this specification.
