0
loosen lug nuts, jack up vehicle after chocking wheels. (place jack stands under vehicle)Remove tire(s), then remove brake caliper(s) using 14mm wrench/ socket. (do not need to disconnect brake line) On the bake side of the brake dust cover there are two more bolts that hold the caliper bracket to the axel assembly, remove those two bolts. Depending on age of vehicle, you may meet some resistance and a rubber mallet or ball peen hammer may be necessary. Tap the rotor near the hub, face and back of rotor to loosen. Again, you may have do this repetively while turning the rotor with your hand so it will be jarred evenly .
What else can I help you with?
How to Adjust the parking brake on an Isuzu rodeo?
adjusting Isuzu rodeo brakes
How do you replace ignition lock cylinder Isuzu rodeo?
How I can replace ignition switch cylinder from Isuzu Rodeo?.
How do you replace coolant temp sensor on a Isuzu Rodeo?
how do you replace coolant temp sensor on a rodeo
How do you replace the shocks on a 1997 Isuzu Rodeo?
How do I remove the front shock bottle pin of my Isuzu rodeo 2000
How do you fix a starter solenoid for a Isuzu Rodeo?
Replace Replace
Can you replace a rear axle from a disc brake 1992 Isuzu Rodeo to a 1992 Isuzu Rodeo with drum brakes just the axle?
I don't think that will work unless you change over to rear disc brakes, the hub should not match.
How do you replace the transmission on a 1999 Isuzu Rodeo?
how do you remove transmission in 1999 rodeo
Replace water pump on a 1994 Isuzu Rodeo?
replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo 6 cylinder
What kind of brake fluid does a 99 Isuzu rodeo use?
DOT 3
How do you replace the Starter on a 1995 Isuzu rodeo 4wd?
Hi, How Do You Replace a Starter on a 1995 Isuzu Rodeo, V6, 3.2 liter engine? Does anyone know where the starter is? Help. How Do You Replace a Starter on a 1995 Isuzu Rodeo, automatic, 4wd, V6, 3.2 liter engine? Does anyone know where the starter is? Thanks alot.
Why would the brakes groan and vibrate on an Isuzu Rodeo when braking the rotors have been turned and new pads installed but it still happens.?
Possible warped rotor. Turning rotors doesn't get rid of warp. Brake shop needs to check for this and replacement of rotor is cure for this problem
How do you replace the brake light for a 2000 rodeo Isuzu?
To replace the brake light on a 2000 Isuzu Rodeo, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips holding the assembly in place and gently pull it out. Twist the bulb socket counterclockwise to remove it, then replace the old bulb with a new one, ensuring it's securely fitted. Finally, reassemble the tail light by reversing the steps and test the new brake light to ensure it works.
