answersLogoWhite

0

Would need to know model no. to be sure but normally you fish the fuel filter from the tank and pull the fuel line out. Now thread twine through the hole and out the fuel cap hole. Cut the new line to a one inch taper, now tie the twine about the middle of the taper add a little motor oil at the tie point and pull through the hole. Replace the fuel filter and you are ready to go.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Need to know the fuel oil mix for craftsman chainsaw Model?

Need to know the fuel oil mix for craftsman chainsaw Model #917.353736.


How do you install replacement fuel line between carburetor and fuel tank on craftsman model 358w356241 18 inch chain saw?

Try watching this video on replacing chainsaw fuel lines: http://www.youtube.com/watch?v=JrXpU70Hmi0


What is the fuel mixture for a Craftsman Model 358351810 chainsaw?

1 gal gas + 2cycle engine oil


How do you replace fuel lines on 2 cycle craftsman chainsaw 358.354830 engine the tank has one barbed fitting and one hole?

Cut a piece of fuel line long enough so the bottom end, with the fuel filter, rests on the bottom of the fuel tank. Run the fuel line, in the same location as the old one was and push the other end onto the barb fitting on the carburetor. http://store.chainsawr.com/


How do you replace a fuel sending unit on a 2001 ford f150?

Chainsaw


What is the fuel ratio for a craftsman chainsaw?

50 to 1 on new ones. The old chain saws could have a ratio as much as 16 to 1.


Is there a diagram of McCullough 3200 chainsaw gas line?

fuel hose lines route


How do you change fuel filter craftsman mower?

Remove the fuel lines from both Ann's of the fuel filter. The lines can be removed by loosening the clamps. Reverse the process to install the new fuel filter.


Craftsman weedwacker is not getting gas?

Check your fuel lines, they come out of there holes on the tank.


What is the fuel ratio for a craftsman chainsaw model 358.356080?

Mix 1/2 pint (8oz.) for every gallon of gas. 16:1 Ratio


What is the routing of the fuel lines on the poulan 2375 chainsaw?

The fuel lines on the Poulan 2375 chainsaw typically consist of two lines: one for drawing fuel from the tank to the carburetor and another for returning excess fuel back to the tank. The longer line, often with a filter at the end, goes into the fuel tank and connects to the carburetor inlet. The shorter line usually connects to the carburetor's return port. It's essential to ensure that these lines are correctly routed to prevent fuel leaks and ensure proper engine performance.


What is fuel line diagram for Craftsman Weedwacker 32 cc?

Diagram showing where the lines from the fuel tank go at the carburetor and the primmer bulb.