The fog light switch on my peugeot 106 is next too the hazard warning switch and the rear window heater switch below the stereo.
To replace the stop light switch on a 2003 Peugeot 106 Zen diesel, first, locate the switch, which is typically situated near the brake pedal. Disconnect the battery to ensure safety, then remove the old switch by unscrewing it or simply pulling it out, depending on the design. Install the new switch by screwing it in place or pushing it back in, then reconnect the battery. Finally, test the brake lights to ensure the new switch is functioning properly.
It would seem that the switch has broken, the switch is located above the pedal, it is easy to replace.
behind the glove box there is a fuse for a light module. its fuse 106.
To change the rear window heater switch on a Peugeot 106, first disconnect the car battery to ensure safety. Remove the trim panel around the switch by gently prying it off, then unscrew the switch from its mounting. Disconnect the wiring harness from the back of the switch and replace it with the new switch. Reassemble the trim panel and reconnect the battery.
the brake light fuse on a peugeot partner is F1O!! STOP SWITCH FUSE!!
The contact switch for the reversing light on a Peugeot 106 is typically located on the gearbox. It is usually mounted on the side of the transmission and is activated when the gearbox is in reverse. To access it, you may need to lift the vehicle and remove any protective covers if necessary. Always consult the vehicle's service manual for specific details and guidance.
have you tried replacing the bulb If its an auto,when replacing the switch on the g/box you have to rotate switch to a certain position.This may be only a few millimetres left or right.Try that
i think it goes hazard light then rear windscreen demister then it is a button that ciculates the air in the car rather than bringing fresh in
You might need to replace your thermostat.
To change the interior light in a Peugeot 106, first, ensure the vehicle is off and the keys are removed. Carefully pry off the light cover using a flathead screwdriver or a similar tool to avoid damaging it. Remove the old bulb by twisting it out, then replace it with a new bulb of the same type. Finally, reattach the cover and test the light to ensure it's working.
20