On the backside of the headlamp assembly you will see large plastic disc with fins sticking off of it. You need to grab this plastic disc in turn it counterclockwise to disengage the tabs and remove it. This can be fairly stiff due to the O-ring sticking on this cover plate. Once this is removed you will see the ball assembly that is held in with a steel spring clip. You have to push down on the one end of the spring clip and unhook from the latch and swivel it out-of-the-way. This will allow the bulb to be removed from the headlight assembly. Depending on your accessories and plastic shielding that you have not removed that is the hardest part of getting to the back of the headlights sometimes.
Read more: Lexus GS 350: how do you replace a low beam headlight bulb - JustAnswer http://www.justanswer.com/lexus/5w3ws-lexus-gs-350-replace-low-beam-headlight-bulb.html#ixzz2FdRpW9Tz
To change the light bulb in a 2008 Lexus RX 350, first, open the hood and locate the headlight assembly. For easier access, you may need to remove the plastic cover. Disconnect the electrical connector from the old bulb, twist the bulb socket counterclockwise to remove it, and then replace it with the new bulb. Finally, reassemble everything by reversing the steps, ensuring the bulb is securely in place.
Remove cap from back of lamp release pin replace bulb
To replace the headlight bulb on a 2000 Ford F-350, first, open the hood and locate the headlight assembly. Remove the retaining clip or screws holding the assembly in place, then gently pull the assembly out. Disconnect the wiring harness from the back of the bulb, twist the old bulb counterclockwise to remove it, and replace it with a new bulb. Finally, reassemble the headlight assembly, reconnect the wiring harness, and test the new bulb to ensure it works.
How do you change a headlight bulb on 1 2004 Hyundai XG 350?
How to replace the tire pressure valve on lexus rx 350?
The low beam bulb, on a Mercedes Benz ML 350, can be accessed from the back of the headlight. Take hold of the bulb, push in and turn, the bulb will come out and can be replaced.
According to the dealer in Tacoma you pay them $350 because they have to take the front bumper off to do that. I don't believe them.
Disconnect the batteries on both sides... negative terminals first... next physcially remove the batteries so you can access the back of each headlamp.. next replace the bulb only from the back access and remember "do not touch the bulb with your hands" oil from your skin will cause the bulb to burn out.
To change the left rear marker light bulb on a 2008 Lexus RX 350, first, open the rear hatch and locate the taillight assembly. Remove the screws or fasteners holding the taillight in place, then gently pull the assembly out. Twist the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble the taillight by reversing the steps. Ensure everything is securely fastened before closing the hatch.
To replace the front left parking lamp on a 2009 Mercedes Benz ML 350, first, open the hood and locate the back of the headlight assembly. Disconnect the electrical connector from the old bulb and twist the bulb socket counterclockwise to remove it. Replace the old bulb with a new one, making sure not to touch the glass with your fingers, and then reassemble by reversing the steps. Finally, reconnect the electrical connector and test the new lamp to ensure it works.
A new Epson PowerLite bulb can cost about $350.
To remove the headlight from a 2004 Ford F-350, start by opening the hood and locating the headlight assembly. Remove the retaining clips or screws that hold the assembly in place, usually found at the top and side of the headlight. Once the screws or clips are removed, gently pull the headlight assembly forward and disconnect the electrical connector. Finally, replace the headlight bulb if needed, and reverse the process to reinstall the assembly.