if you have the big ugly square lights, you have to go in from behind it (open the hood) and twist out the retainer counterclockwise,and pull bulb straight out. remember not to touch the new bulb with your greasy fingers or the oil from them can shatter the halogen bulb.
if you have the dual sealed beams you have to take off the trim rings from the front and unplug the sealed beam straight out of the plug. if you need to adjust the beams after replacing the bulbs, there are two knobs inside (open the hood) to adjust horizontally and vertically.
153624
not sure if this will help but, try mademan.com/mm/how-install-head-gasket-1996-jaguar-xj6.html
Typically a 3.6L Inline 6
1988 Jaguar XJ6 stats Front Speakers: 3-1/2" Rear Speakers -Rear Door: 4" -Rear Deck: 4"
only buy on jaguar deales because is special mineral oil.
The need to take off the refrigerant.
take engine appart and then take plating of light out ant stick crystal bulb in and that's it you got it!
For a 1988 Jaguar XJ6, you should use DOT 4 brake fluid, which is suitable for the vehicle's hydraulic brake system. It's important to ensure that the brake fluid is of high quality and meets the manufacturer's specifications to maintain optimal braking performance. Always check for any contamination in the system and replace the fluid if necessary.
Half an hour
o2 sensor fuel too rich
Fowled or faulty fuel injectors. Replace or repair.
where is located on a 1996 jaguar xj6 starter ?