The oil pressure sending unit is on the top rear of the engine, next to the distributor.
It is on the top right rear corner of the engine. You will have to climb up on the engine to see it.
Screwed into the engine block under the distributor.
sending unit for what, kind of car engine what sending unit
Need to know which sending unit you want to replace, there are several.
Replace sending unit
The oil pressure sensor on the 360 V8 is on the top rear of the engine, next to the distributor.
Right above the oil filter on the front of the engine. You can see it from the top, too.
To replace the temperature sending unit on a Pontiac Montana, first, ensure the engine is cool and disconnect the negative battery cable. Locate the temperature sending unit, usually found near the thermostat housing or engine block, and disconnect the electrical connector. Use a socket or wrench to remove the old sending unit and install the new one, ensuring a proper seal. Finally, reconnect the electrical connector and the battery cable, and check for leaks when you start the engine.
The oil sending unit on a 1999 Dodge Ram 2500 with a 5.9L engine is located on the engine block, near the oil filter. It is typically found on the driver's side, towards the rear of the engine. To access it, you may need to remove some components for better visibility and reach. It's advisable to consult a repair manual for specific details and diagrams.
Remove the oil pressure sending unit retaining ring. Remove the wiring harness from the sending unit. Poll the sending unit out of the engine.
The engine oil sending unit on your Dodge 2.7 liter engine is located in the bottom of the engine. The oil sending unit can be accessed by removing the oil pan.