To replace the temperature sending unit on a Pontiac Montana, first, ensure the engine is cool and disconnect the negative battery cable. Locate the temperature sending unit, usually found near the thermostat housing or engine block, and disconnect the electrical connector. Use a socket or wrench to remove the old sending unit and install the new one, ensuring a proper seal. Finally, reconnect the electrical connector and the battery cable, and check for leaks when you start the engine.
Try to locate the temperature sending unit on the engine and make sure its not a loose wire to the sending unit,if the wire is in place then the sending unit is shot.
Where is the temperature sending unit located on a 2006 Pontiac g6
you will need to take the fuel tank out because it is inside of the tank.just put a new fuel sending unit in and you should be good to go.
what kind of sending unit is it? fuel?,oil pressure?
To replace the fuel sending unit on a 2003 Pontiac Montana, first, disconnect the negative battery cable and relieve the fuel system pressure. Then, remove the rear seat to access the fuel tank access panel. Unplug the electrical connector and fuel lines from the sending unit, remove the retaining ring, and lift out the old unit. Install the new sending unit by reversing the steps, ensuring all connections are secure before reassembling the access panel and rear seat.
where is the oil sending unit on my 2000 bonnieville
around 220
on the right hand side of the block
The sending unit and the fuel pump are all one module in the gas tank.
located on left side of water pump
We need to know which sending unit you speak of. There are several on that vehicle such as temperature sending unit, oil pressure sending unit and fuel gauge sending unit.
There are two...one that sends a signal to the gauge and one that sends a signal to the computer.