you can not do it
How do it replace the stop light bulb
Take the bulb out and replace it with a new one : )
Push the retainers holding the cover on by sticking something into them. Pull the cover off. Replace the bulb.
To replace the rear left stop light bulb on a 2002 Mercedes-Benz ML320, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips securing the tail light, then gently pull the assembly out from the vehicle. Twist the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble the tail light by reversing the steps. Make sure to test the new bulb before securing everything back in place.
The left and right stop light bulbs are reached by pulling off the cover panel to the left and right of the trunk opening. Twist the socket to gain access to the bulb . I believe the bulb pulls out of the socket. To replace the bulb in the high mounted stop light,push in on the back of the cover about an inch from each corner where the housing contacts the shelf. This will free two tabs and the whole assembly should pivot up where you can remove the socket and bulb.
To replace the high mount stop light bulb in a Hyundai Sonata, first, open the trunk and locate the access panel or cover for the high mount light, usually found on the rear deck or trunk lid. Remove the panel by unscrewing or unclipping it, then disconnect the electrical connector from the bulb socket. Twist the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and then reassemble by reversing the steps. Finally, test the light to ensure it’s working properly.
most common cause is a burned out light bulb, if not the bulb,check fuses and stop light switch
Replace bulb - they are double filamented with smaller used fro stop light larger for tailight Check light socket for corrosion, power and ground
When a light bulb blows, it means the filament inside the bulb has broken due to wear and tear. This causes the electrical current to stop flowing, resulting in the bulb no longer emitting light. To fix this, you simply need to replace the blown bulb with a new one.
You need to locate which bulb has to be replaced. After that open the trunk, and find special access panels behind each stop light. Open that panel. Turn the bulb holder counter clock wise. Replace the bulb reinstall everything.
if it is an LED unit you cant you have to change the assembly as a unit
Which one, the middle one or one of the two outside ones and is it the whole lamp or just the bulb you want to replace?