0
well first you have to take the driveshaft out.There are 4 bolts that connect it to the rear, they must be removed and it will slid out of the back of the transmission.Next you want to take the transmission crossmember out.If you unbolt the trans mount it will make it easier to get out.when that's all done the tail end of the trans should drop down.pull the starter out.IT should be on the right side looking towards the front of the car. now look where the trans meets the engine there should be 6 bolts.Remove them and the trans should pull right out.oh don't forget to remove the slave cylinder from the side of the trans first.
What else can I help you with?
How do you replace the idoler pulley on my Nissan 1996 200sx 1.6?
replace 1996 nissan 200sx se 1.6 tension pulley
How do I find a diagram or directions to replace a metal piece that broke off of the clutch and fell on the floor inside a 96 Nissan 200SX?
Metal piece was from the end of the clutch cable.
How do you replace the clutch cable on a Nissan 200sx?
To replace the clutch cable on a Nissan 200SX, first, ensure the vehicle is safely secured and the battery is disconnected. Begin by removing the interior panel to access the clutch pedal assembly, then detach the old cable from the pedal. Next, route the new cable through the firewall and connect it to the clutch fork in the transmission. Finally, adjust the cable tension as needed and reassemble any panels or components that were removed.
How do you remove the clutch on a Nissan 200sx?
To remove the clutch on a Nissan 200SX, start by disconnecting the battery and lifting the vehicle for access. Remove the transmission by unbolting it from the engine, disconnecting any linkages, and supporting it with a jack. Once the transmission is out, unbolt the pressure plate from the flywheel, then take out the clutch disc. Finally, inspect the flywheel and replace or resurface it if necessary before installing the new clutch components.
How do you fix caliper on 1995 Nissan 200sx?
Replace
Where is the clutch fluid in a 96 Nissan 200sx?
The '96 200sx has no fluid for the clutch. This car has a cable operated clutch that needs to be adjusted. If the cable breaks the clutch will not disengage. If the clutch is getting tight it will need lubed. If lubing the cable doesn't work a new cable is needed.
How do you replace a Nissan 200sx ser clutch?
drop the tranny so i have been told by many mechanics except the one i got done they lied, oh we gotta pull the motor, scammers!
How do you disconnect the drive shaft to slide the transmission back so you can replace the clutch plate in a 1987 Nissan 200sx 3.0 6-cyl?
Disconnect the driveshaft at the rear end and pull it out of the trans.
Where is the starter on a Nissan 200sx 1996 located at?
Where is the starter to a Nissan 200sx
How do you replace the starter on a 1987 Nissan 200SX?
cant see bolt on other side off starter, how to replace it ?
How do you replace an ignition switch on a Nissan 200sx?
First you must start by removing the entire ignition, itself, on the Nissan 200SX. It should be fairly easy, you will just need the correct tools. Once you have bought the new ignition switch, attach it to the ignition and then re-install the ignition into the Nissan 200SX.
How do you replace the clutch in a 1991 Nissan 240sx?
ask the mechanic from the Nissan company
